To evaluate ocular wavefront aberrations in keratoconus and describe their effect on visual quality. Department of Ophthalmology Semmelweis University, Budapest, Hungary. Case-control study. Ocular aberrations over a 4.5 mm pupil were measured with a Hartmann-Shack sensor in eyes with keratoconus or subclinical keratoconus or of refractive surgery candidates with normal corneas. Visual quality metrics were calculated using an optical design program. The correlation between Zernike polynomials was evaluated using correlation analysis. Predictors of subclinical keratoconus and keratoconus among ocular aberrations were evaluated. Visual quality (point-spread function, retinal spot radius, Strehl ratio) between groups was compared. Horizontal and vertical coma were significant predictors of subclinical keratoconus (P<.05, r(2)=0.85) and oblique astigmatism and vertical coma of keratoconus (P<.05, r(2)=0.64). Spot radius (P<.05, r(2)=0.66) and the Strehl ratio (P<.05, r(2)=0.64) were significant discriminators in all groups. On correlation analysis, interactions of ocular aberrations were different in keratoconus eyes than in control eyes. In keratoconus eyes, there was a negative correlation between defocus and spherical aberration (r = -0.41) and between astigmatism and secondary astigmatism (r=-0.68). In contrast, spherical aberration correlated positively with tetrafoil (r=0.47) and the positive correlation between vertical coma and vertical tilt decreased (r=0.67 versus r=0.34). Image quality in keratoconus was significantly decreased at equal levels of total root mean square error. A combination of ocular aberrations in eyes with keratoconus decreased image quality.
A novel beam emission spectroscopy observation system was designed, built, and installed onto the Korea Superconducting Tokamak Advanced Research tokamak. The system is designed in a way to be capable of measuring beam emission either from a heating deuterium or from a diagnostic lithium beam. The two beams have somewhat complementary capabilities: edge density profile and turbulence measurement with the lithium beam and two dimensional turbulence measurement with the heating beam. Two detectors can be used in parallel: a CMOS camera provides overview of the scene and lithium beam light intensity distribution at maximum few hundred Hz frame rate, while a 4 × 16 pixel avalanche photo-diode (APD) camera gives 500 kHz bandwidth data from a 4 cm × 16 cm region. The optics use direct imaging through lenses and mirrors from the observation window to the detectors, thus avoid the use of costly and inflexible fiber guides. Remotely controlled mechanisms allow adjustment of the APD camera’s measurement location on a shot-to-shot basis, while temperature stabilized filter holders provide selection of either the Doppler shifted deuterium alpha or lithium resonance line. The capabilities of the system are illustrated by measurements of basic plasma turbulence properties.
1 February 2010 in IEEE Transactions on Nuclear Science
A new Zemax model has been developed, which reliably predicts the light output of scintillator crystal pins for positron emission tomography. Different configurations, including pin shape, surface finish and reflector types are investigated. The simulations use the actual measured wavelength-dependent parameters of the scintillator crystal, of the reflector and of the PMT's components. Good agreement is demonstrated between simulated and measured light output figures for 33 different pin configurations. The highest light output was found by both simulation and experiment for the pins with polished superficies (either polished or diffuse ¿-side) with a non-coupled high reflectivity specular reflector around the superficies and an optically coupled high reflectivity diffuse reflector on the ¿ -side. We also present the measured light output homogeneity of a scintillator array fabricated according to one of the best pin configurations.
We propose a method for performing binary intensity and continuous phase modulation of beams with a spatial light modulator (SLM) and a low-pass spatial filtering system. With our method it is possible to avoid the use of phase masks in holographic data storage systems or to enhance the phase encoding of the SLM by making it capable of binary amplitude modulation. The data storage capabilities and the limitations of the method are studied.