Laser powder-bed fusion (LPBF) enables the production of difficult-to-machine materials with near-net shape and complex geometries. Components made of tool steels produced by LPBF, even using high preheating temperature, tend to show residual porosity, cracks, and high residual stresses. Hot isostatic pressing (HIP) is able to densify components and modify their microstructure. Moreover, compared to conventional heat treatment at ambient pressure, rapid cooling within the HIP vessel can alleviate thermal stresses, warping or cracking during quenching. In this study, the effects of isostatic pressure on microstructure evolution and residual stresses are investigated. Samples were produced by LPBF. Partly, they were conventionally heat treated by austenitizing, quenching, and tempering, partly using a HIP-device with an integrated quenching facility. The microstructure was characterized by optical microscopy, scanning electron microscopy employing energy-dispersive X-ray spectroscopy, and X-ray diffraction analysis. The results showed that besides the densification of the material to the porosity of 0.001%, HIP influenced the microstructure evolution by retarding recrystallization during austenitization due to the pressure and led to slight compressive residual stresses around 11 MPa on the surface of components.

Martensitic steels are tempered to increase the toughness of the metastable martensite, which is brittle in the as-quenched state, and to achieve a more stable microstructure. During the tempering of steels, several particular overlapping effects can arise. Classical dilatometric investigations can only detect effects by monitoring the integral length change of the sample. Additional in-situ diffractometry allowed a differentiation of the individual effects such as transformation of retained austenite and formation of cementite during tempering. Additionally, the lattice parameters of martensite and therefrom the tetragonality was analyzed. Two low-alloy steels with carbon contents of 0.4 and 1.0 wt.% and a high-alloy 5Cr-1Mo-steel with 0.4 wt.% carbon were investigated by dilatometry and in-situ diffractometry. In this paper, microstructural effects during tempering of the investigated steels are discussed by a comparative study of dilatometric and diffractometric experiments. The influence of the chemical composition on the tempering behavior is illustrated by comparing the determined effects of the three steels. The kinetics of tempering is similar for the low-alloy steels and shifted to much higher temperatures for the high-alloy steel. During tempering, the tetragonality of martensite in the steel with 1.0 wt% carbon shifts towards a low carbon behavior, as in the steels with 0.4 wt.% carbon.