SiOx thin films were prepared using magnetron sputtering with different O2 flow rates on a silicon substrate. The samples were characterized using Fourier transform infrared spectroscopy in transmission and reflection, covering a spectral range of 5 to 25 μm. By employing a multilayer model, the values of the complex refractive index that best fit the experimental transmission and reflection results were optimized using the Brendel–Bormann oscillator model. The results demonstrate the significance of selecting an appropriate range of O2 flow rates to modify the SiOx stoichiometry, as well as how the refractive index values can be altered between those of Si and SiO2 in the mid-infrared range.
11 October 2023 in Solar Energy Materials and Solar Cells
In this paper, a precise real-time temperature control system based on infrared (IR) thermometry for domestic induction cooking is presented. The temperature in the vessel constitutes the control variable of the closed-loop power control system implemented in a commercial induction cooker. A proportional-integral controller is applied to establish the output power level in order to reach the target temperature. An optical system and a signal conditioning circuit have been implemented. For the signal processing a microprocessor with 12-bit ADC and a sampling rate of 1 Ksps has been used. The analysis of the contributions to the infrared radiation permits the definition of a procedure to estimate the temperature of the vessel with a maximum temperature error of 5 °C in the range between 60 and 250 °C for a known cookware emissivity. A simple and necessary calibration procedure with a black-body sample is presented.
This work analyzed and compared the optical and photoenergetic properties of low-emissivity coatings made from various dielectric materials deposited through magnetron sputtering following a systematic, comparable method. Different multilayer structures of silver-based low-emissivity coatings were studied using SnO2, ZnO, SiAlNx, and aluminum-doped zinc oxide (AZO, which is inherently a semiconductor, but it fulfils an optical dielectric function in this type of structure). The properties of the coatings were determined by spectrophotometric and sheet resistance measurements. Coatings with AZO as the dielectric layers obtain the best photoenergetic performance because silver growth is more efficient on AZO. We also studied the effect of ion bombardment on AZO and SiAlNx in an attempt to obtain a better low-emissivity coating, achieving better results when etching the dielectric layer with an ion gun. Regarding the structures’ visible transmission, the oxides produced better transmission results. Based on the above, we concluded that AZO had the best optical and photoenergetic properties in our deposition system, observing, in the best-case scenario, improvements in emissivity from 0.083 with SnO2 to 0.058 with AZO and to 0.052 using an ion beam on AZO and improvements in visible transmission from 81.9% with SnO2 to 86.8% with AZO.
Heliostat alignment evaluation is among the main issues in solar tower concentration plant operation and maintenance. This paper describes a novel method used to evaluate heliostat misalignment and its experimental verification. This method provides a different way of visualizing beam centroid pointing errors by generating the complete deviation curve for each axis. This, for example, would be useful for verifying a heliostat’s correct alignment by using a measurement performed out of the receiver target, using these traces to calculate its reflection’s expected location, given a known misalignment. This measurement could be performed during operation simply by including a reflective element in the heliostat and two detector arrays on the tower’s surface. This model has been tested for various types of misalignments of a heliostat at different hours, dates, and heliostat locations. The simulation results have been validated by using an experimental setup at a scale of 1:100.