The decarbonization of industrial processes requires efficient and scalable renewable energy solutions. Concentrated Solar Power (CSP) technology stands out by providing both electricity and high-temperature heat, yet its optimal deployment remains a challenge. This study presents an innovative framework for selecting and optimizing CSP technologies tailored for potential industrial practical applications. In this study, a multi-phase approach is deployed integrating a decision matrix, performance simulations using SOLARPILOT and SAM, and techno-economic evaluation to identify the best CSP solution. The study addresses the feasibility of four candidate CSP technologies, the characteristics of deployment areas, operation parameters such as energy storage time, and characteristics of energy storage material (comparing commercially available materials and an innovative molten salt named FERT-1). The results highlight solar towers as the most suitable technology, while the characteristics of the deployment can lead to over 3.2% difference in annual energy generation (when comparing between two areas, A1 and A2). Regarding energy storage, an optimal storage time of 11 h was identified, achieving a Levelized Cost of Electricity (LCOE) of 24–25 cents/kWh and a 31–32% energy capacity factor. Moreover, regarding energy storage material, the innovative molten salt highlighted improved thermal efficiency.

The growing production of polyurethane foam (PUF) and increasing global PUF waste generation urges the development of a circular economy strategy to promote the recovery of its raw materials, namely polyether polyols, in a sustainable and economically feasible way. This work assesses the promising microwave-assisted PUF aminolysis technology from three different perspectives: (a) evaluating the experimental feasibility and characteristics of the recycled products; (b) modeling an industrially relevant holistic process based on experimental findings to assess energy requirements and c) comparing the environmental impacts ascribed to the production of virgin vs. recycled polyols. The most relevant findings are as follows: (1) the recycled polyols out of MW-aminolysis are indistinguishable from virgin polyols; (2) the potential energy consumption of the overall process (including post-processing steps) for a continuous PUF depolymerization process with a 14.8 kg/h RP production capacity is as low as 1.9 kWh/kg RP and (3) recycled polyols have a substantially lower environmental footprint than virgin polyols in all selected impact categories, ranging from a reduction in CO₂ emissions (38% decrease) to water consumption (74% decrease). These results and analyses pave the way for enhancing material circularity in the PU sector.