Microplastics are an increasing concern due to their widespread occurrence in aquatic environments worldwide. The lack of a harmonised protocol for their reliable quantification remains a major challenge in current scientific efforts. This study presents a comparative evaluation of three protocols for the detection and quantification of microplastics in aqueous samples. The protocols were assessed based on quantification efficiency, risk of particle degradation, staining performance, operational complexity, and cost per sample. Protocol A combined Rhodamine B and ethanol staining with NaCl-based density separation, demonstrating strong isolation performance while maintaining minimal chemical hazards and moderate cost (2.45€ per sample) that could be further reduced to 0.45€ per sample by substituting reagent-grade NaCl with table salt. Protocol B offered moderate isolation capacity and presented the highest risk of particle fragmentation, likely due to the use of acetone and high-temperature digestion. Protocol C, based on the combined use of Nile Red and ZnCl2, also presented a risk of particle fragmentation, resulting in the highest MP count for small and hydrophobic particles. In addition, its high cost (15.23€ per sample) limits its suitability for routine application.
Water scarcity has driven the use of wastewater treatment plant (WWTP) effluents as reclaimed water, highlighting the need to overcome challenges such as the presence of emerging contaminants, particularly microplastics (MPs), which WWTPs are unable to effectively remove. Membrane-based processes, such as microfiltration, have demonstrated high efficiency in the removal of suspended solids, and their application for MP removal is currently under investigation. This study assesses the influence of microfiltration membrane spacer size (1 mil and 80 mil) and geometry—diamond and corrugated—on MP recovery performance, using synthetic wastewaters with varying MPs concentrations. The results indicate the superior performance of large corrugated and small diamond-shaped membranes, as both exhibited the highest and comparable permeate flux, with no MP retention within the membrane element. All microfiltration membranes achieved an 80% recovery of the influent as safe reclaimed water and demonstrated an MP recovery efficiency exceeding 99%, with 100% rejection for fragments and up to 98% rejection for fibres.
Increasing global food demand has led to an intensive use of synthetic fertilisers. In this regard, the use of non-conventional streams such as swine wastewater (SW) and urban sewage sludge liquid fraction (USS) for the production of bio-based fertilisers can increase the sustainability of both the fertiliser industry and agriculture while reducing the reliance on imported nutrients. In this work, USS and SW were assessed for the production of struvite at different PO43−:Mg2+ ratios. Significant differences were found in terms of struvite crystals’ shape and size among both feedstocks due to the different saturation indexes, and it was concluded that PO43−:Mg2+ ratios of 1:2 for SW and 1:1 for USS were the most suitable for obtaining big crystals suitable to be used for direct fertilisation. In addition, it was observed that the crystallisation process is highly dependent on the presence of interfering ions (mainly Ca) that can result in the formation of hydroxyapatite instead of struvite. Finally, recovering struvite from SW and USS could potentially reduce the European import of P by up to 6.5%.