Laser–arc hybrid welding (LAHW) is an advanced welding technology that integrates both laser and arc heat sources within a single molten pool, achieving synergistic benefits that surpass the sum of their individual contributions. This method enhances the welding speed and depth of the fusion, stabilizes the process, and minimizes welding defects. Numerous studies have investigated the principles, synergistic effects, keyhole dynamics, joint performance, and various factors influencing the parameters of laser–arc hybrid welding. This paper begins with an introduction to the classification of LAHW, followed by a discussion of the characteristics of gas-shielded welding, argon arc welding, and plasma hybrid welding. Subsequently, the welding principles underlying laser–arc hybrid welding will be elucidated. To enhance weld integrity and quality, this paper will analyze keyhole behavior, droplet transfer dynamics, welding quality performance, and the generation and prevention of welding defects that affect laser–arc hybrid welding. Additionally, a detailed analysis of the effects of residual stress on the shape, microstructure, and phase composition of the weld will be provided, along with an exploration of the influences of various welding parameters on post-weld deformation and mechanical properties.

The butt joint of an Al alloy ultrathin plate with a thickness of 0.5 mm is realized by a high rotational-speed friction-stir welding process. It overcomes the welding difficulty that the ultrathin plate is often torn, and it cannot be formed by conventional friction-stir welding. The results show that the weld surface is well-formed at a high-rotational speed (more than 8000 rpm), and there are no obvious defects in each area of the joint section. The nugget zone (NZ) is a recovery recrystallization structure dominated by large-angle grain boundaries, with a grain size of about 4.9 μm. During grain growth, the texture is randomly and uniformly distributed, and the strength is balanced. The microhardness of the NZ increases significantly with the increase in rotational speed, and the fluctuation range of hardness value is small. The NZ β–Mg₂Si is finer and significantly less than the base metal (BM). The heat dissipation of the thin plate is fast, so a Cu plate is used as the backing plate to slow down the steep temperature-drop process in the weld area. Compared with a low rotational speed, the precipitation amount of brittle phase Al–Cu–Mg–Cr and Al–Fe–Si–Mn is significantly reduced, which is conducive to improving the mechanical properties of the joint. At a high rotational speed, 12,000 rpm, the best tensile strength of the joint is 220 MPa, which is about 76% of the BM (290 MPa), and the highest elongation is 9.3%, which is about 77.5% of the BM (12%). The fracture mode of the joint is a typical plastic fracture.