Ricardo Valdez

Dr. Ricardo Valdez

orcid

Research Focus & Metrics

Representative Publications

View All Publications
1 April 2018 in Materials Letters
Verified
Journal Article
Closed access
GUG. Urdiana
G. Urdiana
RVRicardo Valdez
Ricardo Valdez
GLG. Lastra
G. Lastra
MVM.á. Valenzuela
M.á. Valenzuela
AOA. Olivas
A. Olivas

1 March 2018 in International Journal of Hydrogen Energy
Verified
Journal Article
Closed access
MAM.A. Armenta
M.A. Armenta
RVRicardo Valdez
Ricardo Valdez
JQJ.M. Quintana
J.M. Quintana
RSRebeca Silva-Rodrigo
Rebeca Silva-Rodrigo
LCL. Cota
L. Cota
AOA. Olivas
A. Olivas

1 March 2013 in Fuel
Verified
Journal Article
Closed access
RVRicardo Valdez
Ricardo Valdez
BPBarbara Pawelec
Barbara Pawelec
JQJ.M. Quintana
J.M. Quintana
AOA. Olivas
A. Olivas

1 June 2022 in RSC Advances
Verified
Journal Article
Open access
PDF file
JYJesus David Yong
Jesus David Yong
RVRicardo Valdez
Ricardo Valdez
MAM.A. Armenta
M.A. Armenta
NANoé Arjona
Noé Arjona
GPGeorgina Pina-Luis
Georgina Pina-Luis
AOAmelia Olivas
Amelia Olivas
In this work, we synthesized five novel iron-based trimetallic layered double hydroxides (LDHs) by the urea-assisted co-precipitation method for the electrocatalytic water oxidation reaction (WOR). In particular, the synthesized electrocatalysts were labeled CoCuFe-LDH, ZnNiFe-LDH, ZnCoFe-LDH, ZnCuFe-LDH, and CoGaFe-LDH. The electrocatalysts were thoroughly characterized by means of Ultraviolet-visible spectroscopy (UV-Vis), N2 adsorption/desorption, and X-ray photoelectron spectroscopy (XPS). We analyzed the changes in the electronic structures, changes in the surface area, and the oxygen vacancies, respectively. X-ray diffraction (XRD) and transmission electron microscopy (TEM) showed that the materials had the hydrotalcite-like structure typical of LDHs. Electrochemical results indicated that the best electrocatalyst was the CoGaFe-LDH achieving an overpotential of 369.9 mV at 10 mA cm−2 and a Tafel slope of 64.8 mV dec−1 in alkaline conditions (KOH 1 M). Additionally, this material displayed a charge transfer resistance (Rct) of 30.1 Ω cm2. Electrochemical measurements indicated that the materials containing Zn2+ exhibit low kinetics; whilst materials with Co2+ or Ga3+ yield the best performances. The catalytic activity of the CoGaFe-LDH can be attributed to the decrease of the Rct caused by electronic effects due to the addition of the Ga3+, lowering the thermodynamic barriers and thus enhancing the electron transfer. This work opens the door for a new approach to design efficient multimetallic catalysts based on the transition metals for WOR.

12 April 2017 in Journal of the Electrochemical Society
Verified
Journal Article
Closed access
PDF file
CQC. M. Quiroa-Montalván
C. M. Quiroa-Montalván
LGL. E. Gómez-Pineda
L. E. Gómez-Pineda
LALorena Alvarez-Contreras
Lorena Alvarez-Contreras
RVRicardo Valdez
Ricardo Valdez
NANoé Arjona
Noé Arjona
MOM. T. Oropeza-Guzmán
M. T. Oropeza-Guzmán
In this work, oxidized ordered mesoporous carbon (OMC-OXI) decorated with magnetite (OMC-OXI-Fe) was synthesized via a soft template technique in combination with a solvothermal method. The OMC-OXI-Fe was characterized by Raman spectroscopy, X-ray diffraction, nitrogen adsorption-desorption, scanning electron microscopy and thermal gravimetric analysis, indicating that the material keeps the OMC structure. The prepared material was used as an electrochemical sensor for the single and combined detection of Cd(II), Cu(II), Hg(II), and Pb(II) ions by square-wave anodic stripping voltammetry (SWASV). The electrochemical results showed that incorporation of magnetite did not modify the charge transfer properties, and maintained the available surface area for the metal ion detection. OMC-OXI-Fe presented a very favorable sensitivity (145.75 μA mg−1 L) and LOD (1.57 μg L−1) for Pb(II), while the responses to Cu(II), Cd(II) and Hg(II) were much lower. These results indicated that the magnetic properties of the modified electrode increased the individual sensitivity for Pb(II) detection and maintained the capacity of simultaneous detection for the studied heavy metal ions. The combination of magnetic mesoporous carbon and electrochemical pulse techniques is a suitable and practical alternative method for the electrochemical detection of hazardous metallic ions in water for human use.

15 March 2022 in Membranes
Verified
Journal Article
Open access
PDF file
Daniella Pompa-MonroyDaniella Pompa-Monroy
Daniella Pompa-Monroy
AIAna Leticia Iglesias
Ana Leticia Iglesias
SDSyed Gulam Dastager
Syed Gulam Dastager
MTMeghana Namdeo Thorat
Meghana Namdeo Thorat
AOAmelia Olivas-Sarabia
Amelia Olivas-Sarabia
Luis Jesús Villarreal-GómezLuis Jesús Villarreal-Gómez
Luis Jesús Villarreal-Gómez
Augmenting bacterial growth is of great interest to the biotechnological industry. Hence, the effect of poly (caprolactone) fibrous scaffolds to promote the growth of different bacterial strains of biological and industrial interest was evaluated. Furthermore, different types of carbon (glucose, fructose, lactose and galactose) and nitrogen sources (yeast extract, glycine, peptone and urea) were added to the scaffold to determinate their influence in bacterial growth. Bacterial growth was observed by scanning electron microscopy; thermal characteristics were also evaluated; bacterial cell growth was measured by ultraviolet-visible spectrophotometry at 600-nm. Fibers produced have an average diameter between 313 to 766 nm, with 44% superficial porosity of the scaffolds, a glass transition around ~64 °C and a critical temperature of ~338 °C. The fibrous scaffold increased the cell growth of Escherichia coli by 23% at 72 h, while Pseudomonas aeruginosa and Staphylococcus aureus increased by 36% and 95% respectively at 48 h, when compared to the normal growth of their respective bacterial cultures. However, no significant difference in bacterial growth between the scaffolds and the casted films could be observed. Cell growth depended on a combination of several factors: type of bacteria, carbon or nitrogen sources, casted films or 3D scaffolds. Microscopy showed traces of a biofilm formation around 3 h in culture of P. aeruginosa. Water bioremediation studies showed that P. aeruginosa on poly (caprolactone)/Glucose fibers was effective in removing 87% of chromium in 8 h.