Trench-edge defects formed during epitaxial recrystallization of trench-bounded amorphized silicon regions are examined as a function of Si substrate crystal orientation. In Si (001), rectilinear features having edges aligned with the crystal’s in-plane ⟨110⟩ directions recrystallize leaving trench-edge defects along all trench edges, whereas the identical features in Si (011) recrystallize without trench-edge defects along trench edges parallel to the crystal’s in-plane ⟨100⟩ direction and with trench-edge defects along trench edges parallel to the crystal’s in-plane ⟨110⟩ direction. The positions and lateral extent of these trench-edge defects suggest that their source is defective epitaxy on slow-growing {111} planes formed during recrystallization. A heuristic model proposed to explain the formation of these {111} planes correctly predicts the essentially defect-free recrystallization seen for rectilinear features in Si (001) having edges aligned with the crystal’s in-plane ⟨100⟩ directions, but cannot completely account for the distinctively curved growth fronts sometimes seen at intermediate stages of recrystallization.
The electrical resistivity was investigated from room temperature down to 1.7 K for the shallow acceptor carbon in GaAs prepared by ion implantation with impurity concentrations between and Good agreement was obtained between the measured resistivities and resistivities calculated by a generalized Drude approach at similar temperatures and doping concentrations. The critical impurity concentration for the metal–nonmetal transition was found to be about
The accumulation of damage in Si implanted with 12C+ was investigated experimentally using aligned Rutherford backscattering analysis. The damage profiles in Si implanted with 12C+ or 11B+ at 50 keV to the same doses and dose rate were compared. It was found that the damage accumulates at a noticeably higher rate by 12C+ implantation than by 11B+, especially for doses ≳2×1015 cm−2. In order to explain our results we suggest that self-interstitial Si atoms are captured by the implanted C atoms, forming complex defects which are stable at room temperature.
The electrical isolation of -type GaAs layers doped with acceptor impurities incorporated in the Ga sublattice (Mg) or As sublattice (C) was studied using proton bombardment. It was found that practically the same proton dose is required to reach complete isolation (isolation threshold dose, in layers doped with either Mg or C of comparable original sheet hole concentration This result is evidence that the sublattice where the acceptor dopant atoms are incorporated does not play any significant role for the isolation formation process in GaAs. The behavior of the recovery of the conductivity during subsequent thermal annealing was found very similar in Mg and C doped samples irradiated to equal proton doses. In samples irradiated to doses the sheet resistance increases during annealing at temperatures reaches a maximum at and then decreases progressively toward the original value. For proton doses ranging from to the isolation is preserved up to the temperature of The temperature of was found to be the upper limit for the thermal stability of the isolation in samples irradiated to doses of
Formation of electrical isolation in n- and p-type In0.49Ga0.51P epitaxial layers grown on semi-insulating GaAs substrates was investigated using proton or helium ion irradiation. Sheet resistance increases with the irradiation dose, reaching a saturation level of ≈109 Ω/□. The results show that the threshold dose necessary for complete isolation linearly depends on the original carrier concentration either in p- or n-type doped InGaP layers. Thermal stability of the isolation during postirradiation annealing was found to increase with accumulation of the ion dose. The maximum temperature at which the isolation persists is ≅500 °C.
In this paper we discuss the structural modifications observed in a buried amorphous Si layer containing high oxygen concentration level (up to at. %) after being implanted at elevated temperature with ions. For implants conducted at temperatures lower than the layer expands via layer by layer amorphization at the front and back amorphous–crystalline (a–c) interfaces. When performed at temperatures above the implants lead to the narrowing of the buried layer through ion beam-induced epitaxial crystallization at both a–c interfaces. Cross section transmission electron microscopy analysis of samples implanted at revealed an array of microtwins and a dislocation network band in the recrystallized material. In samples implanted at only a buried dislocation network band is observed.