1 May 2001 in Journal of Applied Physics
The evolution of the sheet resistance of n-type and p-type conductive InP layers during proton irradiation and the stability of the formed isolation during postirradiation annealing were investigated. It was found that the threshold dose to convert the conductive layer to a highly resistive one is different for n- and p-type samples with similar initial free carrier concentrations. From our results, one infers that the antisite defects and/or related defect complexes formed by the replacement collisions are the carrier trapping centers, where is responsible for electron trapping and for the hole trapping. A time dependence of the was observed after each irradiation step to doses of and higher. This time variation is related to metastable processes involving free carriers. The thermal stability of the isolation of n-type samples is limited to temperatures lower than 200 °C, irrespectively of the irradiated dose. For p-type samples the thermal stability of electrical isolation is extended to 450–500 °C.
28 August 2023 in Thin Solid Films
EJEdelson L.P. Sezerotto Júnior
Edelson L.P. Sezerotto Júnior
27 June 1994 in Applied Physics Letters
The accumulation of damage in Si implanted with 12C+ was investigated experimentally using aligned Rutherford backscattering analysis. The damage profiles in Si implanted with 12C+ or 11B+ at 50 keV to the same doses and dose rate were compared. It was found that the damage accumulates at a noticeably higher rate by 12C+ implantation than by 11B+, especially for doses ≳2×1015 cm−2. In order to explain our results we suggest that self-interstitial Si atoms are captured by the implanted C atoms, forming complex defects which are stable at room temperature.
1 June 2004 in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
15 May 2002 in Journal of Applied Physics
The electrical isolation of -type GaAs layers doped with acceptor impurities incorporated in the Ga sublattice (Mg) or As sublattice (C) was studied using proton bombardment. It was found that practically the same proton dose is required to reach complete isolation (isolation threshold dose, in layers doped with either Mg or C of comparable original sheet hole concentration This result is evidence that the sublattice where the acceptor dopant atoms are incorporated does not play any significant role for the isolation formation process in GaAs. The behavior of the recovery of the conductivity during subsequent thermal annealing was found very similar in Mg and C doped samples irradiated to equal proton doses. In samples irradiated to doses the sheet resistance increases during annealing at temperatures reaches a maximum at and then decreases progressively toward the original value. For proton doses ranging from to the isolation is preserved up to the temperature of The temperature of was found to be the upper limit for the thermal stability of the isolation in samples irradiated to doses of
15 October 2002 in Journal of Applied Physics
Formation of electrical isolation in n- and p-type In0.49Ga0.51P epitaxial layers grown on semi-insulating GaAs substrates was investigated using proton or helium ion irradiation. Sheet resistance increases with the irradiation dose, reaching a saturation level of ≈109 Ω/□. The results show that the threshold dose necessary for complete isolation linearly depends on the original carrier concentration either in p- or n-type doped InGaP layers. Thermal stability of the isolation during postirradiation annealing was found to increase with accumulation of the ion dose. The maximum temperature at which the isolation persists is ≅500 °C.