Icephobic materials and systems are highly desired in regions and seasons where daily life activities are hindered by the presence of ice. The combination of icephobic materials with active de‐icing systems, known as hybrid systems, is a promising way to optimize efficiency in ice removal, while reducing power consumption. However, the development of hybrid systems is limited by their lifespan and the incompatibility of most icephobic materials with the operating mode of the active system. Here we present a hybrid system comprising a gradient polymer coating deposited with initiated chemical vapor deposition and a resonant piezoelectric de‐icing system. The de‐icing performance is evaluated in an icing wind tunnel, where the system is capable of detaching ice blocks in less than 1 s, regardless the ice type and covered area. An in‐depth ice detachment study confirms that ice adhesion reduction is an intrinsic property of the coating, independent from external factors. The nanometric nature of the coating enables efficient operation of the resonant de‐icing systems. The coating shows outstanding durability against the de‐icing cycles, abrasion, water erosion, and delamination. The results showcase the hybrid systems potential in real‐world applications to contrast icing.
Efficient ice protection systems are essential to ensure the operability and reliability of aircraft. In recent years, electromechanical resonant ice protection systems have emerged as a promising low-power alternative to current solutions. These systems can operate in two primary resonant modes: flexural and extensional. While extensional modes enable effective de-icing over large surface areas, their performance can be compromised by interference from flexural modes, particularly in thin, ice-covered substrates where natural mode coupling occurs. This study presents a strategy based on material selection for making the Young’s modulus-to-density ratio uniform. The final objective of this paper is to establish the design rules for a composite leading edge de-icing system. For this purpose, an incremental approach will be used on profiles with different radii of curvature: plate or beam (infinite radius), circular profile (constant radius), NACA profile (variable radius). For beam and plate structures, the paper shows that this coupling can be mitigated by selecting materials with a Young’s modulus-to-density ratio comparable to that of ice. For curved structures, the curvature-induced effect is another source of parasitic flexion, which cannot be controlled solely by material selection and requires careful thickness optimization. This study presents analytical and numerical approaches to investigate the origin of this effect and a design methodology to minimize parasitic flexion in curved structures. The methodology is applied to the design optimization of a glass fiber NACA 0024 airfoil leading edge, the performance of which is subsequently evaluated through icing wind tunnel testing.