Up to now, the measurement of radio-frequency (RF) electric field achieved using the electromagnetically-induced transparency (EIT) of Rydberg atoms has proved to be of high-sensitivity and shows a potential to produce a promising atomic RF receiver at resonance between two chosen Rydberg states. In this paper, we study the extension of the feasibility of digital communication via this quantum-based antenna over a continuously tunable RF-carrier at off-resonance. Our experiment shows that the digital communication at a rate of 500 kbps can be performed reliably within a tunable bandwidth of 200 MHz near a 10.22 GHz carrier. Outside of this range, the bit error rate (BER) increases, rising to, for example, 15% at an RF-detuning of $\pm 150$ MHz. In the measurement, the time-varying RF field is retrieved by detecting the optical power of the probe laser at the center frequency of RF-induced symmetric or asymmetric Autler-Townes splitting in EIT. Prior to the digital test, we studied the RF-reception quality as a function of various parameters including the RF detuning and found that a choice of linear gain response to the RF-amplitude can suppress the signal distortion. The modulating signal can be decoded at speeds up to 500 kHz in the tunable bandwidth. Our test consolidates the physical basis for reliable communication and spectral sensing over a wider broadband RF-carrier, which paves a way for the concurrent multi-channel communications founded on the same pair of Rydberg states.

Rydberg atoms have been extensively utilized in microwave measurement with high sensitivity, which has great potential in the field of communication. In this study, we discuss the digital communication based on a Rydberg atomic receiver under simultaneously coupling by resonant and near detuning microwaves. In addition, we verify the feasibility of the Rydberg atom-based frequency division multiplexing (FDM) in microwave communication. We demonstrate the principle and performance of the atom-based FDM receiver by applying amplitude modulation (AM) and frequency modulation (FM), respectively. To demonstrate the actual communication performance at different data transfer rates, we consider monochromatic images as an example. The experimental results show that the maximum acceptable data transfer rate of both AM and FM is about 200 kbps, whereas their maximum bit error rates (BER) is less than 5%. When compared with the traditional electronic receiver, this atomic receiver, which is compatible with FDM, has numerous advantages, such as small size, low power consumption, and high sensitivity. Furthermore, this receiver has a strong ability of anti-electromagnetic interference, and the signals transmitted do not interfere with each other in different channels.

Highly excited Rydberg atoms in a room-temperature vapor cell are promising for developing a radio-frequency (RF) electric field (E-field) sensor and relevant measurement standards with high accuracy and sensitivity. The all-optical sensing approach is based on electromagnetically-induced transparency and Autler-Townes splitting induced by the RF E-field. Systematic investigation of measurement uncertainty is of great importance for developing a national measurement standard. The presence of a dielectric vapor cell containing alkali atoms changes the magnitude, polarization, and spatial distribution of the incident RF field. In this paper, the field distortion of rubidium vapor cells is investigated, in terms of both field strength distortion and depolarization. Full-wave numerical simulation and analysis are employed to determine general optimization solutions for minimizing such distortion and validated by measuring the E-field vector distribution inside different vapor cells. This work can improve the accuracy of atom-based RF E-field measurements and contributes to the development of related RF quantum sensors.

A novel antenna gain measurement method based on quantum interaction of highly excited alkali Rydberg atoms and radiated radio frequency electric field from an antenna under test is proposed in this letter. The method allows gain value to be determined by measuring RF field induced splitting frequency of an electromagnetically induced transparency window, antenna feeding power, and finite measurement range. The antenna gain measurement for a K -band standard gain horn antenna is presented to demonstrate the measurement setup and process, and the results are consistent with conventional measurements. The method is promising due to its advantages of simplicity, accuracy, and low cost. This work is of major significance for developing atom-based RF field and antenna characterization.

The bandwidth and sensitivity of traditional terahertz detection devices are limited by material properties and working temperature. Here, we proposed a four-level Rydberg atom detection method, which can realize real-time detection for the absolute strength of the terahertz electric field under room temperature with the detection bandwidth of 0-5 THz. By theoretical analysis and formula derivation, the relation among the terahertz electric field strength, excitation energy level, coupling photoelectric field strength, gas cell temperature and electromagnetically induced transparency (EIT) signal are studied in detailed. The NEP of this method is proven to be 10 ⁻¹⁷ W/Hz ^1/2 in the range of 0-1 THz, which is three orders of magnitude smaller than that of the traditional optimal thermal detection system. This research has important reference value for the later high-sensitivity detection and application development of terahertz waves

Herein, a microfabricated millimeter-level vapor alkali cell with a high hermeticity is fabricated through a wet etching and single-chip anodic bonding process. The vapor cell, containing Rb and N₂, was investigated in a coherent population trapping (CPT) setup for the application of a chip-scale atomic clock (CSAC). The contrast of CPT resonance is up to 1.1% within the only 1 mm length of light interacting with atom. The effects of some critical external parameters on the CPT resonance, such as laser intensity, cell temperature, and buffer gas pressure, are thoroughly studied and optimized. The improved microfabricated vapor cell also exhibited great potential for other chip-scale atomic devices.