Up to now, the measurement of radio-frequency (RF) electric field achieved using the electromagnetically-induced transparency (EIT) of Rydberg atoms has proved to be of high-sensitivity and shows a potential to produce a promising atomic RF receiver at resonance between two chosen Rydberg states. In this paper, we study the extension of the feasibility of digital communication via this quantum-based antenna over a continuously tunable RF-carrier at off-resonance. Our experiment shows that the digital communication at a rate of 500 kbps can be performed reliably within a tunable bandwidth of 200 MHz near a 10.22 GHz carrier. Outside of this range, the bit error rate (BER) increases, rising to, for example, 15% at an RF-detuning of $\pm 150$ MHz. In the measurement, the time-varying RF field is retrieved by detecting the optical power of the probe laser at the center frequency of RF-induced symmetric or asymmetric Autler-Townes splitting in EIT. Prior to the digital test, we studied the RF-reception quality as a function of various parameters including the RF detuning and found that a choice of linear gain response to the RF-amplitude can suppress the signal distortion. The modulating signal can be decoded at speeds up to 500 kHz in the tunable bandwidth. Our test consolidates the physical basis for reliable communication and spectral sensing over a wider broadband RF-carrier, which paves a way for the concurrent multi-channel communications founded on the same pair of Rydberg states.

Highly excited Rydberg atoms in a room-temperature vapor cell are promising for developing a radio-frequency (RF) electric field (E-field) sensor and relevant measurement standards with high accuracy and sensitivity. The all-optical sensing approach is based on electromagnetically-induced transparency and Autler-Townes splitting induced by the RF E-field. Systematic investigation of measurement uncertainty is of great importance for developing a national measurement standard. The presence of a dielectric vapor cell containing alkali atoms changes the magnitude, polarization, and spatial distribution of the incident RF field. In this paper, the field distortion of rubidium vapor cells is investigated, in terms of both field strength distortion and depolarization. Full-wave numerical simulation and analysis are employed to determine general optimization solutions for minimizing such distortion and validated by measuring the E-field vector distribution inside different vapor cells. This work can improve the accuracy of atom-based RF E-field measurements and contributes to the development of related RF quantum sensors.