The capacity of some plants to access water and nutrients at depths greater than one meter is a critical functional trait that confers resistance to drought and impacts both belowground and shallow soil processes. Here, we report water and strontium isotopic data from an alpine meadow transect showing the correlation between water and nutrient acquisition depths. The isotopic compositions of Sr ( 87 Sr/ 86 Sr ratio) and water in rock and soil, and in plant leaf tissues, reveal that deeper-rooted plants acquire a higher proportion of water, Sr, and cation nutrients that are derived from the saprolite, a zone of silicate weathering, than shallow-rooted grass. A three-decade dendrochemical record reveals that reductions of wet precipitation drive deep-rooted plants to acquire cation nutrients from deeper saprolite or bedrock regions. Thus, the depth of cation nutrient acquisition by deep-rooted plant species at this site is tightly coupled with, and likely determined by, water availability in soil, saprolite, and bedrock. The enhanced uptake of cations as well as water from deeper saprolite zones could impact the rate of bedrock weathering and watershed chemistry during drought.
Compressional (P) and shear (S) wave velocities of tungsten single crystals along the [100] and [110] directions were measured using ultrasonic interferometry at room temperature up to 11.3 GPa. Least-squares fitting of VP[100], VS[100], VP[110], and pressure to finite strain (FS) equations yields the elastic constants: C11 = 523.5(5) GPa, C12 = 205.1(32) GPa, and C44 = 160.8(4) GPa, along with their respective pressure derivatives: C11′=6.20(2), C12′=3.35(1), and C44′=1.65(6). Using the Voigt–Reuss–Hill approximation, the elastic moduli were derived as KS0=311.2(22)GPa and G0=160.2(7)GPa, along with their respective pressure derivatives: KS0′=4.30(4) and G0′=1.56(1). The Debye temperature of tungsten was determined to be 380.7(8) K, showing good agreement with previous calorimetric measurements. The elastic anisotropy increases slightly from 1.01(1) at ambient pressure to 1.03(1) at 11.3 GPa, suggesting that tungsten remains nearly isotropic under compression. Poisson's ratio slightly increased from 0.281(3) to 0.288(3) with pressure. Additionally, Pugh's ratio decreased from 0.512(4) to 0.494(4), while Pettifor's ratio increased from 0.148(10) to 0.175(10) as pressure reached 11.3 GPa. These results suggest that tungsten is weakly ductile compared to the critical thresholds for ductile behavior (i.e., Pugh's ratio 0, indicating ductile behavior), but that its ductility increases marginally under pressure.
Compressional (VP) and shear (VS) wave velocities of polycrystalline vanadium were measured simultaneously up to 11.5 GPa at room temperature using ultrasonic interferometry in a multi-anvil press. Complex softening behavior in VS and resulting shear moduli are discovered, possibly revealing a precursor to the reported phase transition within 30–60 GPa. The current data enables a comprehensive assessment of the elastic and mechanical properties of vanadium at high pressures, including bulk and shear moduli, Young’s modulus, Poisson’s ratio, and Pugh’s ratio. Through fitting to the 3rd-order finite strain equations, the elastic moduli and their pressure derivatives were determined to be KS0 = 151 (2) GPa, G0 = 46.9 (8) GPa, K’S0 = 3.47 (5), and G’0 = 0.62 (1). These experimental results allow us to compare with and benchmark the existing Steinberg–Guinan models for extrapolations to extreme pressure and temperature conditions.