The aim of the study is a comparative analysis of micromechanical and microtribological properties of the cathodic arc-deposited Mo, Cr, and Ta coatings using nanoindentation and scratch test techniques as well as a microtribological dry sliding test with wear tracks post-examination and worn volume determination using interference profilometry. A new scratch test technique based on the statistical processing of registered sclerograms during a multi-pass scratch test well adopted for the scratch resistance assessment of rough surfaces is suggested. New approaches to microtribological testing based on the indentation tester equipped with an additional precision rotational stage are proposed, which could fill the gap between macro- and nano-scale. X-ray diffraction analysis reveals the structure of the studied coatings and phase compositions of the coating-substrate interface.
A method of obtaining test and training data sets has been developed. These sets are intended for training a static neural network to recognise individual and double defects in the air-gas path units of a gas-turbine engine. These data are obtained by using operational process parameters of the air-gas path of a bypass turbofan engine. The method allows sets that can project some changes in the technical conditions of a gas-turbine engine to be received, taking into account errors that occur in the measurement of the gas-dynamic parameters of the air-gas path. The operation of the engine in a wide range of modes should also be taken into account.
The article is dedicated to the problem of unmanned airplane wing leading edge damages influence on its integral aerodynamic characteristics. Experimental research results of a vortex system formed as a result of the damage are described.
27 December 2023 in Electronics and Control Systems
The article presents a new method of predicting the time of completion of a transport task. The method is based on the created mathematical model of the transport task process and on artificial intelligence methods. The choice of the optimal transportation route is based on the conditions of a specific task. A new method of choosing the optimal route is presented, taking into account the influence of such factors as weather conditions, day of the week, time of day, condition of the road surface, presence of residential complexes and other factors. The purpose of the study is to optimize the method of building a transport route using neural networks. The work presents the improvement of the general method of optimizing the transport process, the development of a neural network training method for predicting the time of the transport process, the development of a simulation mathematical model of the transport process and the determination of the model parameters and the effectiveness of the method verification. Research methods: methods of mathematical modeling, simulation modeling, Monte Carlo method, methods of artificial intelligence based on neural networks.