The iliotibial tract (tract) is an important structure for the biomechanics of both the hip and knee joint. While a detailed characterization of its mechanical properties might help to better understand its specific role in the load transfer from the pelvis to femur and tibia, determination of those properties is complicated by its particular structure of thin fibers in the fresh state. Moreover, although the tracts mechanical properties are often derived from cadaveric material chemically fixed with either ethanol or formaldehyde, the influence of such fixation methods remains to be elucidated. Aim of this study was to determine Young's modulus (tensile modulus, YM) of the tract. We hypothesized that either ethanol or formaldehyde fixation would significantly increase the YM compared to the tracts condition in a fresh state. 13 specimens of tract were gained from donators. The ends of the probes were plastinated with resin creating a sharp interface between the clamp and the probe to prevent material slippage. The specimens were measured in their fresh state, under ethanol- and formaldehyde-fixed conditions and re-measured after rinsing with tap water. The YM of the fresh probes averaged 397.3N/mm(2) with a standard deviation (SD) of 151.5N/mm(2). The YM of the ethanol-fixed specimens was significantly higher (673.2N/mm(2), SD 328.5N/mm(2), p<0.05). After rinsing with tap water, the YM decreased to 95% of the fresh condition value (377.4N/mm(2), SD 144.5N/mm(2), non-significant change from fresh). After formaldehyde fixation, the YM reached 490.3N/mm(2) (SD 143.0N/mm(2), p<0.05). When the formaldehyde-fixed specimens were rinsed, the YM was 114% of the value of the fresh condition (452.6N/mm(2), SD 115.1N/mm(2), non-significant change from fresh). This study found a significant influence of the chemical fixation method on the YM of the IT tract. If such fixation is required, our results suggest using a treatment with ethanol and subsequent rinsing that results in minimal changes to the tracts YM. Furthermore, plastination of the ends of the specimens could be crucial to allow in vitro determination of valid YM of ligaments data that can then be integrated with confidence in further finite element analyses.

The ligaments of the human sacroiliac joint (SIJ) were investigated morphometrically. A macroscopical study was performed to measure the anterior sacroiliac ligament (ASL), the interosseous sacroiliac ligament (ISL), and the posterior sacroiliac ligament (PSL), applying different methods of ligament visualization. Little is known about the SIJ ligaments, especially about the ISL. Pelvic computer simulations neglect these ligaments due to the lack of information. Computer simulations of the SIJ ligaments may help to improve the clinical outcome of SIJ operations. Seven-Tesla MR images, CT images, and corresponding thin slice plastinates of the SIJ of 1 male and 1 female specimen were obtained. Serial sections of the SIJ of 32 frozen specimens (13 males, 19 females) were generated to gather measurements of the SIJ ligaments. By means of the MR images and the plastinates, a virtual reconstruction of the SIJ ligaments was accomplished. Parallelepipeds were attributed to the cranial, middle, and caudal parts of all SIJ ligaments. This allowed precise measurements and statistical comparison including positional relationships. The ISL volumes and origin surfaces were the largest. Statistically, the ASL and PSL parameters were larger in males, while the ISL parameters were larger in females. The height of the cranial ASL part showed large negative correlations in spite of positive correlations of the other heights. The combined use of high-resolution MRI and thin slice plastination allows precise reconstructions of the SIJ ligaments. With these techniques, the ligaments can be visualized in situ and described morphometrically if based on substantive data. The SIJ ligaments are gender-dependent. This has to be taken into account for pelvic computer simulations.