Three-dimensional concrete printing (3DCP) offers an accurate, formwork-free, and resource-efficient construction process; however, the absence of vibration and compaction often results in increased porosity and reduced durability. This study investigates the influence of nano-calcium carbonate (NC), acting as a nano pore-filler, on the durability and other physical properties of 3DCP. NC was incorporated at dosages of 0–3% by weight of cement, and specimens were fabricated using a laboratory-scale 3D printing machine. Durability performance was evaluated after 120 days under plastic-wrapped curing, sulfuric acid exposure, and magnesium sulfate immersion. In addition, thermal conductivity and sound absorption were measured to identify the effect of pore structure modification by NC. The results show that NC enhances matrix densification and mechanical performance up to an optimal dosage of approximately 2%, beyond which its effectiveness decreases. Under magnesium sulfate immersion, the strength decreased slightly but improved with increasing NC content up to about 2%. In the case of sulfuric acid exposure, the strength decreased significantly after 120 days; however, it still increased with increasing NC content. Incorporating NC into 3DCP appears to provide improved resistance to both magnesium sulfate and sulfuric acid exposure. Thermal conductivity increased with NC addition, indicating improved solid-phase continuity, whereas sound absorption decreased due to the reduction in porosity. These findings demonstrate that nano-calcium carbonate can effectively refine pore structure and improve durability-related performance, contributing to extended service life and more sustainable 3D-printed cementitious materials in the built environment.
Continuous carbon fiber composites have high strength-to-weight ratios, excellent corrosion resistance, and impressive durability. In civil engineering, continuous carbon fiber reinforcement is commonly employed in carbon fiber-reinforced polymer (CFRP) systems, whereas its direct incorporation into low-carbon alkali-activated binder (AAB) matrices remains relatively unexplored. This study presents a preliminary investigation into the fabrication of continuous carbon fiber-reinforced alkali-activated binder (CFR-AAB) composites using a hand lay-up technique. To facilitate fiber impregnation and laminate fabrication, the AAB matrix was first optimized by varying the liquid-to-binder ratio, sodium silicate-to-sodium hydroxide ratio, and sodium hydroxide concentration to balance flowability, setting time, and compressive strength. Using the optimized AAB matrix, which satisfied the adopted flowability and initial setting-time requirements for hand lay-up fabrication while achieving a compressive strength of 48.6 MPa, CFR-AAB laminates containing 12, 24, and 36 carbon fiber plies with symmetric stacking sequences were fabricated and mechanically evaluated. The incorporation of continuous carbon fiber had only a limited influence on compressive strength, with all CFR-AAB configurations achieving values above 46 MPa. In contrast, flexural strength increased substantially from 4.21 MPa for the plain AAB matrix to 70–85 MPa for the CFR-AAB composites, representing more than a sixteen-fold improvement. Failure observations showed that the flexural response was governed mainly by interlaminar delamination and shear-related damage rather than fiber rupture, highlighting the importance of fiber–matrix and interlaminar interactions in controlling composite performance. Overall, this study demonstrates the technical feasibility of manufacturing CFR-AAB composites using a simple hand lay-up process and establishes a foundation for lightweight, low-carbon structural composites. Future research should focus on improving fiber–matrix interfacial bonding and impregnation quality, optimizing laminate configurations, and evaluating the long-term mechanical and durability performance of the composites.