Renewable energy must be prioritized by humankind, mainly if there is an expected increase of 50% in energy consumption by 2030 and climate change scenarios are also confirmed. Urban areas consume 70% of the available energy on the planet. Brazil, the largest country in South America, concentrates more than 85% of its population in urban areas, facing a challenge to increase the renewable power plants in its energy matrix. This work presents the solar radiation components behavior for the city of Salvador to contribute with initiatives for the use of solar energy resource. Firstly, a radiometric platform was implemented to obtain direct measurements of global (and diffuse (components of incoming solar radiation at the surface. The knowledge of is an important requirement to support photovoltaic system projects, and there is no information on direct measurements of this component in the State of Bahia. The diffuse radiation measurement device (DRMD) was designed and built for this purpose. The measurements of components performed in this research were submitted to a specific quality control, statistically analyzed and used to evaluate the performance of different empirical models to represent the behavior of in the tropical coastal city. The results demonstrate the potential to explore solar energy in the city of Salvador, with annual values of sunshine higher than 2200 and average daily intensities of and equal to 18.7 and 7.35 respectively. The analysis of the diurnal cycle shows that in summer reaches a maximum of 4.2 and in the rainy season it reaches a minimum of 3.7 , both at noon, and in summer the is 35% of the and it is 46% in the rainy season.
Cavitation has been widely explored to enhance physical and chemical processes across various applications. This study aimed to model the key characteristics of a cavitation jet, induced by a triangular-orifice nozzle, using both experimental and numerical methods. Optical instrumentation, a pressure transducer and the Reynolds-Averaged Navier–Stokes (RANS) equations were employed. Optical instrumentation and high-speed photography detected the two-phase flow generated by water vaporization, revealing a mean decay pattern. Irradiance fluctuations and photographic evidence provided results about the light transmission dynamics through cavitating jets. Pressure fluctuations exhibited similar growth and decay, supporting optical instrumentation as a viable method for assessing cavitation intensity. Experimental data showed a strong relationship between irradiance and flow rate (R2 = 0.998). This enabled the correlation of the standard deviation of instantaneous pressure measurements and normalized flow rate (R2 = 0.977). Furthermore, vapor volume fraction and normalized flow rate reached a correlation coefficient of 0.999. On the simulation side, the SSG-RSM turbulence mode showed better agreement with experimental data, with relative deviations ranging from 2.1% to 6.6%. The numerical results suggest that vapor jet length is related to vapor fraction through a power law, enabling the development of new equations. These results demonstrated that anisotropic turbulence modeling is essential to reproduce experimental observations compared to mean flow properties. Based on the agreement between the numerical model and the experimental data for mean flow quantities, a formulation is proposed to estimate the jet length originating from the nozzle, offering a predictive approach for cavitating jet behavior.
This study presents the development and validation of a high-speed optical data acquisition system for detecting and characterizing hydrodynamic cavitation downstream of a triangular nozzle. The system integrates a PIN photodiode, a transimpedance amplifier, and a high-sampling-rate microcontroller. Its performance was first evaluated using controlled sinusoidal signals, and statistical stability was assessed as a function of the number of acquired samples. Experiments were subsequently conducted in a converging–diverging conduit under biphasic flow conditions, where mean irradiance, standard deviation, and frequency spectra were analyzed downstream of the nozzle. The optical signal distributions revealed transitions in flow behavior associated with cavitation development, which were quantified through statistical metrics and spectral features. The Strouhal number was estimated from dominant frequencies extracted from the spectra, exhibiting a non-monotonic dependence on the Reynolds number, consistent with changes in flow structure and turbulence intensity. Spectral analysis further indicated frequency bands associated with energy transfer across turbulent scales and bubble dynamics. Overall, the results demonstrate that the proposed optical system constitutes a viable and non-intrusive methodology for detecting and characterizing cavitation intensity in a way that complements other optical and acoustic methods.
27 November 2020 in Anais Congresso Brasileiro de Energia Solar - CBENS
Para garantir a eficiência dos dispositivos de energia solar é imprescindível determinar o comportamento da radiação incidente em superfícies inclinadas, sendo necessário o conhecimento dos componentes de radiação solar global e difusa incidentes em uma superfície horizontal. O objetivo principal deste trabalho é caracterizar a evolução mensal e horária das componentes do balanço de radiação de onda curta na cidade de Salvador-Ba. As medidas coletadas pela Plataforma de Monitoramento Ambiental do Laboratório de Micrometeorologia e Modelagem, após um robusto controle de qualidade, apresentam um ciclo diurno bem definido e com amplitudes de radiação global de 30 MJm^-2dia^-1 no verão, no inverno a radiação global decai em média 36%. A radiação difusa apresenta amplitudes máximas de 14 MJm^-2dia^-1 no mês de novembro, 54% da radiação global, indicando o notável potencial de energia disponível.
27 November 2020 in Anais Congresso Brasileiro de Energia Solar - CBENS
O nordeste Brasileiro (NEB) é a região com maior potencial solar do Brasil. O incentivo para instalação de sistemas fotovoltaicos no país e o aumento dos estudos relacionados à radiação solar para geração de energia elétrica tem crescido de maneira mais ativa nesta década. Estudos de eficiência de painéis solares são necessários para um melhor aproveitamento desse precioso recurso renovável. Para viabilizar os estudos de eficiência em painéis fotovoltaicos, se faz necessário ter em mãos os dados de radiação solar global (IG) de radiação difusa (IDIF). Estações automáticas de instituições governamentais, como o Instituto Nacional de Meteorologia (INMET) medem e disponibilizam apenas dados de IG. Para coleta de dados de radiação difusa, foi proposto neste artigo a construção de um dispositivo de medição, baseado fundamentalmente no anel de sombreamento. O dispositivo construído apresentou-se funcional e contribuiu para a coleta de dados de IDIF na cidade de Salvador. Uma breve análise de condição de céu foi realizada a partir dos dados teóricos de radiação no topo da atmosfera (IT) e dados coletados de IG e IDIF. As análises dos dados permitiram a classificação da condição do céu conforme índice de claridade (Kt).
Shell-and-tube heat exchangers often operate under harsh conditions that induce fouling, leading to loss of thermal efficiency, production downtime, and increased maintenance costs. Conventional cleaning procedures generally require scheduled or unscheduled shutdowns, with direct operational and financial impacts. In this context, ultrasonic cavitation has been investigated as a strategy for fouling prevention and equipment cleaning, with the potential to reduce cleaning downtime or support in-service mitigation strategies. This work presents the development of an acquisition platform based on a miniaturized, waterproof acoustic probe designed for operation inside 8 mm tubes under cavitating ultrasonic fields, with the goal of experimentally mapping the relative acoustic response amplitude and dominant frequency in U-tube heat exchangers. The system integrates a piezoelectric sensing element embedded in protective encapsulation, signal-conditioning electronics, and a high-sampling-rate acquisition module. Experiments were conducted in a reduced-scale exchanger comprising 90 access ports and measurement depths up to 775 mm, using 28 kHz ultrasonic transducers. The probe successfully captured both the spectral content and the spatial variation of the voltage-based acoustic response along the tube bundle, revealing position-dependent amplitude variations and dominant-frequency measurements concentrated around the imposed excitation frequency. The analysis supported the definition of a reduced set of representative sampling locations, decreasing acquisition time while preserving the main spatial trends relevant to the objectives of this study. The procedures established here provide an experimental basis for future studies on the application of ultrasound to fouling-mitigation strategies in industrial thermal systems.