Ion Badea

Mr. Ion Badea

orcid

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 April 2025 in Applied Sciences
Verified
Journal Article
Open access
PDF file
IBIon Badea
Ion Badea
TATudor-George ALEXANDRU
Tudor-George ALEXANDRU
Diana PopescuDiana Popescu
Diana Popescu
This study evaluates the feasibility of 3D-printed polymer composite external fixator (EF) rings as a cost-effective alternative to stainless steel fixators, focusing on hybrid fixators for complex tibial fractures. Mechanical performance was assessed in three stages: (1) evaluating the initial EF–tibia configuration under axial loading and wire pre-tension conditions; (2) analyzing the stiffness evolution and weight-bearing capacity during early healing with progressive callus formation; and (3) optimizing ring designs through numerical analysis to improve structural performance under increased pre-tension. The results showed that, for the metallic EF, the axial displacement under one-leg stance reached 8.41 mm without pre-tension, reducing to 6.83 mm at 500 N pre-tension, though transverse displacement remained significant, suggesting the need for higher wire tension. Callus formation enhanced the load-bearing capacity, as expected. However, excessive displacements persisted under the one-leg stance, indicating that full weight-bearing should be delayed beyond two weeks for a fracture gap of 3 mm. A ring design assessment showed that full-ring configurations with two wires per ring improved performance. The 3D-printed full-ring design made of carbon-fiber-reinforced polylactic acid (PLA-CF) reduced stress by 85% at 500 N pre-tension compared to the initial configuration, remaining within allowable limits. While confirming feasibility, the study highlights the need for geometric refinements to accommodate higher preloads and improve transverse stiffness.

Verified
Journal Article
Open access
PDF file
IBIon Badea
Ion Badea
TATudor-George ALEXANDRU
Tudor-George ALEXANDRU
Diana PopescuDiana Popescu
Diana Popescu
BFBaciu Florin
Baciu Florin
This research investigated the feasibility of 3D-printed external fixator (EF) rings made from carbon fiber reinforced polyamide 6 (PA6-CF) as an alternative to the conventional metallic counterpart. The study integrated tensile testing with digital image correlation (DIC) in as-printed and cold plasma-sterilized conditions, finite-element analysis (FEA) under wire loading, topology optimization for material and energy reduction, and evaluation of printability limits for large PA6-CF rings. The average Young’s modulus was 4.76 GPa and the maximum tensile strength was 60.5 MPa for as-printed samples, decreasing by 6.4% and 10.4% after sterilization, respectively. Using these properties as model inputs, FEA predicted safety factors larger than 1.42 for all configurations under 1000 N wire pretension, while topology optimization targeted up to 50% mass reduction without compromising ring stiffness. The study also revealed challenges in the printability of PA6-CF for large and thin components, including dimensional contraction, significant warping and moisture-induced defects, requiring an experienced 3D printer operator.