The purpose of this study is to monitor the battery performance of plug-in hybrid electric vehicles (PHEVs) on a chassis dynamometer using the US06, NEDC, and EPA highway driving cycles. The chassis dynamometer simulates vehicle operation and driving conditions and allows for precise simulation of pre-defined driving cycles, including simulations of acceleration, deceleration, stopping, and re-acceleration on the road. In the case of the US06 driving cycle, the results for (EV mode) compared with energy consumption during electric testing revealed a consistent decrease in the SOC (state of charge) due to the rapid response of the electric motor distribution to the changing power, as well as electric power fluctuations during driving conditions. Under the NEDC, the test results for electric power (EV) compared with energy consumption during electric testing revealed that the SOC gradually decreased at the start of the test due to low driving speeds. Towards the end, at around 800 s, an increase in driving speed resulted in a noticeable drop in SOC. The electric power varied during the driving cycle in this test due to the motor’s rapid response to changes in power distribution while driving. For the EPA Highway driving cycle test, the test results for electric power (EV) compared with energy consumption during continuous electric testing indicated a gradual decrease in the SOC at first due to low driving speeds. As the driving speed increased after about 300 s, the SOC rapidly decreased. Because of the motor’s quick response to changes in the power distribution while driving, the electric power varied according to the driving cycle.
This paper aims to develop a technique for controlling fuel pressure in a common rail injection system using proportional integral derivative control (PID). Test fuel was blended fuel between diesel and biodiesel of 93:7 %vol. The multiple injection strategies were tested under the injection pressure of 350 to 800 bar. Injection duration was varied in the range of 0.82-5 ms with a constant dwell time of 6.4 ms. Injection period was set as 171 ms, corresponding to the engine idle speed of 750 rpm. Suction control valve was controlled by pulse width modulation. The results showed that fuel pressure in the common rail can be controlled by PID controller for different injection strategies with fluctuation pressure in the rail less than 1%. The fluctuation pressure trends to have lower fluctuation pressure in case of higher pressure.