This paper presents the results of a series of cyclic nonsymmetrical thermally loaded model-scale tests conducted on floating pile groups, with and without a rigid cap in saturated clay. The energy pile in each group was subjected to 10 two-way (heating–cooling) thermal cycles with an amplitude of 15 °C to investigate the potential effects of a rigid cap on the thermomechanical behavior of energy pile groups. It was found that the rigid cap restrained the expansion/contraction of the energy pile in response to temperature change and reduced its irreversible settlement, resulting in a lower differential settlement between the energy and nonenergy piles. Consequently, a lower tilting was observed in the pile group with a rigid cap. In addition, the thermally induced axial load was significantly increased (especially in cooling mode) due to the restriction of a rigid cap. The thermomechanical load transfer profile of the energy pile was also affected by it, resulting in the downward transmission of shaft resistance.

Negative skin friction (NSF) has been one of the important factors in the design of pile foundation; especially, the influence of water level on the pile negative skin friction should be paid attention. In this paper, a series of model tests were carried out to analyze the bearing characteristic of the pile group influenced by groundwater level. The pile axial force and negative skin friction, settlement, and soil pore pressure were investigated. The results showed that both the water level rising and lowering cycle could increase the axial force of the pile along the upper part of the pile, yet reducing it along the lower part of the pile; both the axial force and the negative skin friction of the pile presented a feature of time effect; the value of negative skin friction was positively correlated with that of the pile head load, and the neutral plane ranged from 0.57 L to 0.64 L as the water level changed; the soil featured settling in layers, and the change of pore water pressure was accordant with the water level changing regulation.

Coral sand is widely distributed in coastal areas and used as a soil foundation in an increasing number of projects. Historical records show that the liquefaction and lateral spreading of coral sand foundations occurred many times during earthquakes, resulting in serious geological and engineering disasters. Based on a rigid drainage pile, a PCC pile (Large Diameter Pipe Pile by using Cast-in-place Concrete) and drainage body are innovatively combined into a new drainage PCC pile, to reduce the harm caused by liquefaction and lateral spreading of the coral sand foundation. In this study, the seismic response of the subgrade-embankment-seawall system on the coral sand liquefaction site was simulated using a shaking table. The excess pore water pressure ratio, acceleration, average foundation settlement, seawall displacement, embankment deformation, and pile body bending moment of the ordinary pile foundation and new drainage PCC pile foundation under seismic loads of , , and on the coral sand site were analyzed and compared. Compared with ordinary pile foundations, the excess pore water pressure ratio, pile bending moment, seawall displacement, foundation settlement, and embankment deformation of the new drainage PCC pile foundation were markedly reduced, while acceleration increased, which showed that the new drainage PCC pile had a positive anti-liquefaction effect on the coral sand foundation.