A modular reconfigurable robot (MRR) is considered as a system of systems; that is, a robot control system consists of modular systems. For an MRR, onboard tracking of multiple objects is one of the most challenging tasks. This is because the task requires lots of computation resources, but an MRR system is constrained by several physical limitations. To enhance the computing performance of an MRR control system, a novel approach to organizing a distributed computing system is proposed. The key components of the proposed approach are FPGA-based specialized computational cores (SCCs). An SCC for tracking objects is designed to utilize spare resources of the MRR module's control devices. Analysis and experiments on a real testbench are performed to illustrate that the proposed approach can enhance overall computing performance of an MRR control system without adding additional components. As such, weight and dimensional parameters are saved; unnecessary power consumption and heat generation are reduced. One experimental example shows that the proposed SCC enables a Kalman filter to track objects up to 100 times faster than a comparable solution implemented with microcontrollers, while the whole distributed computing system can outperform a similar one built on high-performance CPUs.
The paper proposes a new approach for FPGA reconfiguration based on usage of the open-source synthesis and place-and-route tools. The well-known partial reconfiguration technologies assume pre-compilation of all required FPGA configurations by the designer. In autonomous intelligent control systems it can become quite a strong limitation, due to control law couldn't be changed on-board without using external FPGA development tool. The paper proposes automatic Verilog code generation and synthesis directly on embedded controller, followed by full FPGA reconfiguration. The experimental results shows, that the resource usage of the FPGA configurations built by open-source tools are comparable to the ones built by well-known commercial toolchain).
This paper proposes a novel architecture for control systems of modular reconfigurable robots that combines centralized and decentralized approaches to achieve the best ration between efficiency, fault-tolerance and cost-efficiency.
The paper proposes a conceptual model for information interaction between intelligent control system elements, and presents analysis of results of tests on navigation systems for group control of autonomous robots designed for indoor use. The study investigated accuracy of position determination for single and multiple labels, the effect of external interference in the form of radio equipment and smoke, and system power consumption depending on settings. The paper proposes information transmission channels for intelligent control systems at the strategic, tactical and execution levels.
The paper describes an original architecture of a control system for the execution level of discrete machinery manufacturing. The architecture combines traditional approach that uses a SCADA system to monitor the condition of the production equipment and a system for production tasks execution based on Forth virtual machines for every automated work station. The proposed architecture will make it possible to successfully combine operations with different degrees of automation into a single manufacturing process, and also to substitute manual operations with automated ones without changing the technical documentation. Conducted experiments prove the applicability of this approach and the potential for further researches in this field.
Modern electrical grippers have lower life-cycle costs compared to pneumatic ones. Furthermore, they provide force control, making it possible to grasp objects with different fragility using a single device. At the same time, electrical grippers have a higher end-effector weight, installed on the robot’s flange and lower closing speed, preventing them from replacing pneumatic solutions in high dynamic Pick and Place applications. This research faces both issues by synthesizing a novel gripper mechanism based on a Torque Distribution Gearbox, which makes it possible to relocate the electric motors to the static frame of a delta robot. The proposed gripper not only has a lower mass and a higher closing speed than competitive electric solutions, but it also provides unlimited rotation around the vertical axis. The performance of the gripper was tested in experimental studies, which showed that a created aluminum prototype provides a precise force control in the range from 3 N to 48 N with an accuracy not worse than 1.27 N. Moreover, its finger’s speed is 3.1–56 times higher than market available electrical grippers, which makes it comparable by this parameter with pneumatic solutions used in high dynamic Pick and Place applications.