The Poly[Styrene-Butyl acrylate-(P-vinylbenzyl trimethyl ammonium chloride)] P(St-BA-VBT) nanospheres with N+(CH3)3 functional groups were successfully prepared and applied to modify cotton fabrics using a pad-dry process. The obtained cationic cotton fabrics were dyed with pad-steam dyeing with reactive dye. The results show that the appropriate concentration of nanospheres was 4 g/L. The sodium carbonate of 25 g/L and steaming time of 3 min were suitable for dyeing cationic cotton with 25 g/L of C.I. Reactive Blue 222. The color strength and dye fixation rates of dyed cationic cotton fabrics increased by 39.4% and 14.3% compared with untreated fabrics. Moreover, sodium carbonate and steaming time were reduced by 37.5% and 40%, respectively. The rubbing and washing fastness of dyed fabrics were equal or higher 3 and 4–5 grades, respectively. Scanning electron microscopy (SEM) images revealed that the P(St-BA-VBT) nanospheres randomly distributed and did not form a continuous film on the cationic cotton fiber surfaces. The X-ray photoelectron spectroscopy (XPS) analysis further demonstrated the presence of cationic nanospheres on the fiber surfaces. The cationic modification did not affect the breaking strength of cotton fabrics.
Rapid activation of sodium persulfate (SPS) for the degradation of C.I. Reactive Red 218 (RR218) was achieved using Ti3C2 MXene reduction of trace Fe3+. The degradation rate of RR218 reached 97.7% using a mixture containing 3 g L−1 of SPS, 3.35 mg L−1 of Fe3+ and 60 mg L−1 of MXene stirred at 25 °C for 30 min. The intense reduction of Ti3C2 MXene triggers the Fe3+/Fe2+ cycle thereby accelerating the activation of SPS. When reactive dyes were degraded by Fe3+/SPS/MXene process, ·OH played a major role. The dye degradation capacity of the Fe3+/SPS/MXene process decreased after 5 cycles of recycling. In addition, the wastewater treated under these conditions resulted in high dyeing efficiencies in reuse experiments. This study not only improves the understanding of the catalytic reaction of MXene but also provides a wastewater treatment and reuse process with low metal consumption and high efficiency.
Cobalt-based catalysts were synthesized using the molten metal salt method and applied for the degradation of reactive dyeing wastewater. The results demonstrated a degradation of 97.1% for the C.I. Reactive Red 195 solution under the following conditions: 1.0 g/L of Co@MXene, 3 g/L of peroxymonosulfate (PMS), treated at 25 oC for 36 min with initial pH of 7. After adding 20 g/L of NaCl, the dye degradation rate increased to 5.57 times compared to the original rate 0.0894 min−1, but the difference in final degradation was not significant. The enhanced degradation was attributed to the combined action of hydroxyl radicals (•OH), sulfate radicals (SO4•−), and singlet oxygen (1O2). Notably, the Co@MXene catalyst maintained a high dye degradation percentage of 93.5% even after being recycled ten times. The treated dye residue can be recycled for dyeing cotton fabrics with reactive dyes. This study achieves rapid treatment of dye wastewater with wide applicability and provides valuable insights into dye wastewater treatment and environmental remediation.