The accuracy of the dynamic model of a robot plays an important role for robots performing highly dynamic tasks. Quadruped robots are often performing highly dynamic tasks and in order to be able to do that, fine and precise control of all joints is necessary. Friction compensation can play an important role in accomplishing this. A friction identification procedure for quadruped legged robots is presented in this paper. The procedure consists of a predefined joint motion that minimizes the joint coupling and collects the necessary data for friction estimation. Using the identified friction terms, a PD torque controller with friction compensation was implemented. The identification procedure and the torque controller are tested on a Solo12 quadruped robot using MuJoCo simulation software and on the real robot.
Differential drive mobile platforms are common in the robotic world, for teaching, research, and tackling different applications. These platforms are very agile and can perform movement, trajectory following, and positioning tasks. To test different control algorithms for a mobile platform, its model must be used to simulate the real-world platform. This allows students and researchers to investigate different control strategies and fine-tune control algorithms for specific tasks. This paper presents a simulation model of the mobile platform, which was developed with the aim of matching the physically realized platform as much as possible. The created model can be intuitively used for control design and simulation.
With the popularity of quadruped robots, the main challenge they must overcome is traversing unstructured environments. Current methods that allow modern robots to traverse challenging terrain are unsuitable for situations at the edge of robot performance, where torque limits and contact forces must be carefully considered. This paper will investigate a way of generating feasible center of mass (CoM) trajectories applicable in such cases. A feasible CoM trajectory is one that the robot can perform considering contact, torque, and reachability constraints. We improve the existing method for finding feasible CoM regions, yielding a thirty times speedup so that it can run under 1 ms. Based on that improvement, we introduce a new iterative CoM planner that sequentially solves prioritized constrained IK and computes feasible regions. That way, we guarantee the satisfaction of contact constraints, torque constraints, and reachability. The planned motion was performed using a whole-body controller. We tested the approach on high-fidelity simulation and on real Solo12 quadruped, achieving the control loop frequency of 1 kHz. The whole codebase has been disclosed on GitHub.
This paper considers a trajectory tracking problem in motion control of a mobile platform. The platform is designed to have differential drive, Arduino microcontroller, Bluetooth connectivity and is battery powered, thus representing a complete mechatronic system. The task at this stage was to provide the platform motion along simple desired trajectories, such as straight lines and curves. During its motion, the platform draws its trajectory on the surface, upon which motion accuracy can be evaluated. Odometry approach is used in solving this task where each wheel motor is driven within a cascaded control structure with conventional digital controllers. Experimental results of several tests are presented and analyzed.
This paper proposes a control structure suitable for trajectory tracking tasks performed by a differential drive mobile platform, operating under external disturbances. To address these challenges, a discrete-time sliding mode controller (DSMC) is implemented within the inner velocity control loops, offering robust behavior. In addition to enhanced robustness, the proposed controller effectively eliminates wheel slippage. The performance of the proposed system is evaluated through simulations and compared to the control system having conventional digital PI controllers in the velocity control subsystems.