The accuracy of the dynamic model of a robot plays an important role for robots performing highly dynamic tasks. Quadruped robots are often performing highly dynamic tasks and in order to be able to do that, fine and precise control of all joints is necessary. Friction compensation can play an important role in accomplishing this. A friction identification procedure for quadruped legged robots is presented in this paper. The procedure consists of a predefined joint motion that minimizes the joint coupling and collects the necessary data for friction estimation. Using the identified friction terms, a PD torque controller with friction compensation was implemented. The identification procedure and the torque controller are tested on a Solo12 quadruped robot using MuJoCo simulation software and on the real robot.
Differential drive mobile platforms are common in the robotic world, for teaching, research, and tackling different applications. These platforms are very agile and can perform movement, trajectory following, and positioning tasks. To test different control algorithms for a mobile platform, its model must be used to simulate the real-world platform. This allows students and researchers to investigate different control strategies and fine-tune control algorithms for specific tasks. This paper presents a simulation model of the mobile platform, which was developed with the aim of matching the physically realized platform as much as possible. The created model can be intuitively used for control design and simulation.
This paper deals with the magnet position estimation based on the measurements from multiple Hall sensors. Estimation of the position is obtained from trained artificial neural networks. Data are gathered using a custom sensor board that has eight three-axis Hall sensors on it, and correlation between magnetic field and position was determined to be able to estimate position in X and Y directions. First measurements were made to determine the optimal height of the magnet for later data gathering. The outcome of the research was evaluated by comparing the ground truth with the estimated values of the best-trained network to determine the error of estimation. Precise measurement of the position of the magnet is intended to be used for the development of a tactile sensor that estimates the contact force through the displacement of the magnet in the deformable layer.
This paper considers a trajectory tracking problem in motion control of a mobile platform. The platform is designed to have differential drive, Arduino microcontroller, Bluetooth connectivity and is battery powered, thus representing a complete mechatronic system. The task at this stage was to provide the platform motion along simple desired trajectories, such as straight lines and curves. During its motion, the platform draws its trajectory on the surface, upon which motion accuracy can be evaluated. Odometry approach is used in solving this task where each wheel motor is driven within a cascaded control structure with conventional digital controllers. Experimental results of several tests are presented and analyzed.
1 January 2025 in Facta universitatis - series: Electronics and Energetics
This paper presents the new concept of Medicine Vending Machine (MVM), called Personalized Medicine Vending Machines (PMVM), motivated by the need to increase social distancing during the COVID-19 pandemic. The conceptual model, the scenarios of using PMVM, and all the necessary preconditions are provided. This paper proposes modifying the existing MVM concept, which can provide better social distancing in times of pandemics and epidemics, emphasizing personalization and picking up prescribed therapy. The medical information system MEDIS.NET has been used as a keystone in the development of PMVM. Pharmacies and patients use prescription data stored in patient electronic health records in MEDIS.NET to provide all conditions needed for the operation of PMVM. Real data from the Pharmacy Institution Nis and Health Center Nis are used to define the scenarios for the use of PMVM. The proposed PMVM would be a new service for smart cities that can contribute to the significant increase of the efficiency of smart cities during the combat against COVID-19 and any similar pandemics in the future.
This paper proposes a control structure suitable for trajectory tracking tasks performed by a differential drive mobile platform, operating under external disturbances. To address these challenges, a discrete-time sliding mode controller (DSMC) is implemented within the inner velocity control loops, offering robust behavior. In addition to enhanced robustness, the proposed controller effectively eliminates wheel slippage. The performance of the proposed system is evaluated through simulations and compared to the control system having conventional digital PI controllers in the velocity control subsystems.