Pyrolysis and gasification processes were utilized to study the feasibility of producing fuels from landfilled plastic wastes. These wastes were converted in a gasifier at 700–900 °C. The equivalence ratio (ER) was varied from 0.4–0.6 with or without addition of a Ni− Mg− La/Al2O3 catalyst. The pyrolysis and gasification of plastic wastes without catalyst resulted in relatively low H2, CO and other fuel gas products with methane as the major gaseous species. The highest lower heating value (LHV) was obtained at 800 °C and for an ER of 0.4, while the maximum cold gas efficiency occurred at 700 °C and for an ER of 0.4. The presence of the Ni− Mg− La/Al2O3 catalyst significantly enhanced H2 and CO production as well as increasing the gas energy content to 15.76–19.26 MJ/m3, which is suitable for further usage as quality fuel gas. A higher temperature resulted in more H2 and CO and other product gas yields, while char and liquid (tars) decreased. The maximum gas yield, gas calorific value and cold gas efficiency were achieved when the Ni− Mg− La/Al2O3 catalyst was used at 900 °C. In general, addition of prepared catalyst resulted in greater H2, CO and other light hydrocarbon yields from superior conversion of wastes to these gases. Thus, thermochemical treatment of these problematic wastes using pyrolysis and gasification processes is a very attractive alternative for sustainable waste management.
In this work, Sacha inchi (Plukenetia volubilis L.) residues were used as biomass feedstocks in catalytic upgrading pyrolysis with SBA-15, which is a substance synthesized from coal fly ash (CFA), using alkali fusion, followed by hydrothermal treatment (SBA-15-FA). The catalytic activity of fly ash-derived SBA-15 was investigated through the fast pyrolysis of Sacha inchi residues for upgrading the pyrolysis vapors using the analytical pyrolysis-GC/MS (Py-GC/MS) technique. The pyrolysis temperature was set at 500 °C and held for 30 s while maintaining the Sacha inchi residues to catalyst ratios of 1:0, 1:1, 1:5, and 1:10. In addition, the SBA-15s synthesized from chemical reagent and commercial SBA-15 were evaluated for comparison. The non-catalytic fast pyrolysis of Sacha inchi (SI) mainly consisted of fatty acids (46%), including chiefly linoleic acid (C18:2). Other compounds present were hydrocarbon (26%) and nitrogen-containing compounds (8.7%), esters (9.0%), alcohols (6.4%), and furans (3.6%). The study results suggested that the SBA-15-FA showcased a high ability to improve aliphatic selectivity (mainly C5–C20) and was found to be almost 80% at the biomass to catalyst ratio of 1:5. Moreover, the increase in catalyst contents affected the enhancement of hydrocarbons yields and tended to promote the deoxygenation reaction. Interestingly, the catalytic performance of SBA-15 derived from fly ash could be compared to that of the commercial SBA-15 in terms of producing hydrocarbon compounds as well as reducing oxygenated compounds.
2 May 2025 in Process Safety and Environmental Protection