Tayfun Okan

Tayfun Okan


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 October 2019 in Microwave and Optical Technology Letters
Verified
Journal Article
Closed access
PDF file
TOTayfun Okan
Tayfun Okan

4 April 2020 in International Journal of RF and Microwave Computer-Aided Engineering
Verified
Journal Article
Closed access
PDF file
TOTayfun Okan
Tayfun Okan

30 June 2020 in International Journal of RF and Microwave Computer-Aided Engineering
Verified
Journal Article
Closed access
PDF file
TOTayfun Okan
Tayfun Okan
NANursel Akçam
Nursel Akçam

2 October 2020 in International Journal of Electronics
Verified
Journal Article
Closed access
OYOzan Yavasoglu
Ozan Yavasoglu
NANursel Akcam
Nursel Akcam
TOTayfun Okan
Tayfun Okan
Orthogonal Frequency Division Multiplexing (OFDM) is a widely used technique for wireless communications. But uncoded OFDM is not sufficient by itself, that is why channel coding is included to increase the system performance. In this study, concatenated Bose Chaudhuri Hocquenghem (BCH) and Convolutional Coded (CC) OFDM system is investigated for multipath fading channel with Additive White Gaussian Noise (AWGN). The simulation results show that the proposed concatenated code needs lower Signal-to-Noise Ratio (SNR) when compared with single BCH code, single convolutional code and even with other concatenated systems. Throughout the simulations BCH coding is performed with 128, 256, 512 Fast Fourier Transform (FFT) lengths; whereas convolutional coding is performed with 1/2, 1/3 coding rates. Furthermore, interleavers are added to the system to prevent the burst errors that occur over the channel. With the proposed system, the best result is obtained by using BCH(511,340) and CC(3,1,7) concatenation which is 8.2 dB SNR value for 10(-3) Bit Error Rate (BER). This result is very close to ideal AWGN channel value, which is 8 dB for 10(-3) BER.

1 June 2022 in Gazi University Journal of Science
Verified
Journal Article
Closed access
PDF file
RTReşat TÜZÜN
Reşat TÜZÜN
NANursel Akçam
Nursel Akçam
TOTayfun Okan
Tayfun Okan
This paper introduces a compact microstrip low-pass filter (LPF) with a very sharp rejection. The proposed LPF is designed to be used for electronic warfare in defense industry. It has 62 dB/GHz attenuation rate, 10 GHz of stopband width and 48.6 dB of stopband attenuation. Moreover, it also has a wide passband and has a high cut-off frequency (f_c) of 6 GHz. The designed filter has been fabricated using alumina (Al2O3) substrate and titanium-gold (Ti-Au) coating on top of that with thin film technique in a clean room. The experimental measurements of the proposed LPF show great agreement with the simulation results, which validates that the presented filter is convenient to be used for applications up to C-band in electronic warfare systems.

20 March 2023 in Ömer Halisdemir Üniversitesi Mühendislik Bilimleri Dergisi
Verified
Journal Article
Open access
TOTayfun Okan
Tayfun Okan
SASeda Habergoturen Ates
Seda Habergoturen Ates
NANursel Akçam
Nursel Akçam
In this study, an antenna is proposed that operates at THz spectrum for sixth generation (6G) short-range future wireless communications. A modified photonic band gap (MPBG) substrate is employed to design an octagonal ring shaped microstrip patch antenna with wideband and high gain properties. Unlike the conventional photonic band gap (PBG) form, the proposed MPBG substrate structure is created by variable sized cylindrical air holes. The radii of each air cylinder in the row is determined with the help of particle swarm optimization (PSO) algorithm, where the goal is set to achieve the highest gain and impedance bandwidth (S_11≤-10 dB) possible. The simulation results of the antennas that are built on 1) non-PBG, 2) conventional PBG and 3) the proposed MPBG substrate structures are compared. It is observed that the radiation performance is most enhanced by implementing MPBG structure. In comparison to the antenna without PBG, the reported MPBG structure offers almost 300% gain and 11% bandwidth improvement. To summarize, the designed antenna with its proposed MPBG substrate structure achieves an excellent radiation performance within a wide operating bandwidth.