A newly developed series of polylactide (PLA)-based composites filled with hybrid lignin–carbon nanotube (CNTs) particles were studied using thermal and dielectric techniques. The low CNT content (up to 3 wt%) aimed to create conductive networks while enhancing particle–polymer adhesion. For comparison, PLA composites based on lignin and CNTs were also examined. Although infrared spectroscopy showed no significant interactions, calorimetry and dielectric spectroscopy revealed a rigid interfacial PLA layer exhibiting restricted mobility. The interfacial polymer amount was found to increase monotonically with the particle content. The hybrid-filled PLA composites exhibited electrical conductivity, whereas PLA/Lignin and PLA/CNTs remained insulators. The result was indicative of a synergistic effect between lignin and CNTs, leading to lowering of the percolation threshold to 3 wt%, being almost ideal for sustainable conductive printing inks. Despite the addition of lignin and CNTs at different loadings, the glass transition temperature of PLA (60 °C) decreased slightly (softer composites) by 1–2 K in the composites, while the melting temperature remained stable at ~175 °C, favoring efficient processing. Regarding crystallization, which is typically slow in PLA, the hybrid lignin/CNT particles promoted crystal nucleation without increasing the total crystallizable fraction. Overall, these findings highlight the potential of eco-friendly conductive PLA composites for new-generation applications, such as printed electronics.

Printed electronics (PE) have emerged as a rapidly growing technology owing to their potential for low-cost fabrication, flexibility, and scalable device manufacturing. The dependence on fossil-based components raises environmental concerns, leading the scientific community toward sustainable solutions, aiming to reduce the accumulation of electronic waste (e-waste) in the environment and the emission of toxic gases, as well as to offer a circular solution in the sector. This review presents an in-depth overview of biobased polymeric materials in printed and organic (bio-)electronics. Firstly, the principal printing techniques are presented in detail. The review proceeds by outlining the various biobased synthetic and natural polymers, along with their blends, that are employed in the fabrication of biobased substrates for printed devices. Finally, the review emphasizes the existing challenges and constraints in the field of PE, along with the promising opportunities for its future advancement.

A depth study of optical, isothermal crystallization and mechanical properties was conducted on a series of poly(lactic acid) (PLA) nanocomposites based on lignin/multi-walled carbon nanotubes (MWCNTs) hybrid nanomaterial. The preparation was performed via solution casting followed by melt mixing. For comparison reasons, a group of PLA/lignin polymeric materials were prepared. Infrared spectroscopy (FTIR) did not reveal any significant impact on the main peaks of the nanocomposites by the incorporation of the additives. The optical properties were strongly affected by the content of the additive, as long as the thermal transitions parameters as evaluated from the differential scanning calorimetry (DSC) show important differences between cold and melt crystallization. X-ray diffraction (XRD) showed the semicrystalline behavior of the materials, while during isothermal crystallization experiments, the hybrid conductive nanomaterial acted as nucleation agent by promoting crystallization. Under evaluation of the mechanical properties, Young’s modulus tensile parameter increased significantly while the content of the hybrid nanomaterial increased, and the bending experiments of the materials with low content of the additives did not break. Thus, these substrates could be promising candidates for engineering applications, such as printed electronics.