Gokul Nathan

Mr. Gokul Nathan


Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 June 2025 in Air
Verified
Journal Article
Open access
PDF file
IKIan Kinsella
Ian Kinsella
APAnna Petrbokova
Anna Petrbokova
RYRongjie Yang
Rongjie Yang
Zheng LiuZheng Liu
Zheng Liu
GNGokul Nathan
Gokul Nathan
SMSepehr Makhsous
Sepehr Makhsous
Soldering is a common engineering practice that releases airborne particulate matter (PM), contributing to significant long-term respiratory risk. The health impact of this exposure is significant, with up to 22% of soldering workers worldwide being diagnosed with conditions such as occupational asthma, restrictive lung disease, and bronchial obstruction. Studies have reported that soldering can produce PM2.5 concentrations up to 10 times higher than the U.S. Environmental Protection Agency’s (EPA) 24 h exposure limit of 35.0 μg/m3—posing significant respiratory and cognitive health risks under chronic exposure. These hazards remain underappreciated by novice engineers in academic and entry-level industrial environments, where safety practices are often informal or inconsistently applied. Air purification systems offer a mitigation approach; however, performance varies significantly with model and placement, and independent validation is limited. This study uses an indoor air quality monitoring system consisting of six AeroSpec sensors to measure PM2.5–10 concentrations during soldering sessions conducted with and without commercial air purifiers. Tests were conducted with and without a selection of commercial air purifiers, and measurements were recorded under consistent spatial and temporal conditions. Datasets were analyzed to evaluate purifier effectiveness and the influence of placement on pollutant distribution. The findings provide independent validation of air purifier capabilities and offer evidence-based suggestions for minimizing particulate exposure and improving safety in laboratory soldering environments.

29 June 2025 in GPS Solutions
Verified
Journal Article
Closed access
PDF file
GNGokul Nathan
Gokul Nathan
ACAlperen Cucioglu
Alperen Cucioglu
SMSep Makhsous
Sep Makhsous

29 July 2026 in Air
Verified
Journal Article
Open access
PDF file
Zheng LiuZheng Liu
Zheng Liu
GNGokul Nathan
Gokul Nathan
XXXueyicheng Xu
Xueyicheng Xu
MYMingcheng Yang
Mingcheng Yang
KPKavimitiran Pasupathi
Kavimitiran Pasupathi
SMSepehr Makhsous
Sepehr Makhsous
Public fireworks shows are widely used for national holiday celebrations, religious ceremonies, and sports events. However, fireworks produce short-lived atmospheric particulate matter (PM) peaks, posing a risk to spectators’ health. Every year, public fireworks shows expose over 140 million Americans to episodic transient PM2.5 peaks that exceed air quality standards by up to 10 times in the United States alone. Yet the magnitude and timing of this representativeness gap have not been measured within an event. This paper investigates the Independence Day fireworks display over Lake Union, Seattle, WA, USA, using a low-cost PM network deployed up to 2 km from the launch site. We evaluated the network observations against routine monitoring data from regulatory stations within 10 km of the launch site and generated a backward–forward Lagrangian stochastic dispersion model, calibrated with the network. Spectator zone PM2.5 concentrations varied by over threefold across sensors within 1.5 km. Duration above the World Health Organization (WHO) 24 h PM2.5 guideline concentration level at network sensors varied from 1 min to nearly 30 min, and regulatory hourly averaging retained 57% of the near-field peak signal on average and only 22% in the worst case. Peak detection at some regulatory stations was delayed by one to two hours compared with the network. The dispersion model, using only network data and public regional wind data, captured the launch site location to within ~100 m and provided minute-scale estimates of PM2.5 and PM1 concentrations across the spectator zone. The findings demonstrate and quantify, for a single event, the representativeness gap expected when transient near-field fireworks plumes are evaluated using spatially sparse and hourly averaged regulatory observations.

1 October 2026 in IEEE Sensors Letters
Verified
Journal Article
Closed access
KAKarlen Aleksanyan
Karlen Aleksanyan
XXXueyicheng Xu
Xueyicheng Xu
Zheng LiuZheng Liu
Zheng Liu
HLHaitao Lin
Haitao Lin
GNGokul Nathan
Gokul Nathan
AMAlexander V. Mamishev
Alexander V. Mamishev