Graphitic carbon nitride (g-C3N4) is emerging as one of the most promising non-metallic semiconductors for the degradation of pollutants in water by photocatalytic processes. Its exceptional reduction–oxidation (redox) potentials and adequate band gap of approximately 2.7 eV give it the ability to absorb in the visible light range. However, the characteristic sensitivity to light absorption is limited, leading to rapid recombination of electron–hole pairs. Therefore, different strategies have been explored to optimize this charge separation, among which the formation of heterostructures based on g-C3N4 is highlighted. This review addresses recent advances in photocatalysis mediated by g-C3N4 heterostructures, considering the synthesis methods enabling the optimization of the morphology and active interface of these materials. Next, the mechanisms of charge transfer are discussed in detail, with special emphasis on type II, type S, and type Z classifications and their influence on the efficiency of photodegradation. Subsequently, the progress in the application of these photocatalysts for the degradation of water pollutants, such as toxic organic dyes, pharmaceutical pollutants, pesticides, and per- and polyfluoroalkyl substances (PFAS), are analyzed, highlighting both experimental advances and remaining challenges. Finally, future perspectives oriented towards the optimization of heterostructures, the efficiency of synthesis methods, and the practical application of these in photocatalytic processes for environmental remediation.
Red Amaranth (RA) Azo dye is a persistent pollutant in wastewater and stands as a toxicological risk, which has led to the development of effective methods for its removal and photocatalytic degradation. Therefore, CeO2 nanoparticles were synthesized by a controlled precipitation method, and Ultraviolet-Visible (UV–Vis) analysis and Tauc plots yielded a band gap of ~3.24 eV. The CeO2 nanoparticles showed the fluorite cubic phase, and nearly spherical particles with an average size of ~10 nm. Nitrogen physisorption revealed a type IV isotherm with a Brunauer–Emmett–Teller (BET) surface area of 85.27 m2·g−1 and a total pore volume of 0.27 cm3·g−1, indicating a mesoporous structure and high surface accessibility. The chemical behavior showed Ce and O, consistent with phase purity. Photocatalytic performance was evaluated in 20 ppm aqueous solution of RA under 365 nm UV irradiation (LED 100 W), with a temperature of ~20 °C and a 15 min dark adsorption step. Concentration decay was followed at λmax = 520 nm by Lambert–Beer. The degradation efficiency η and pseudo-first-order kinetic were obtained from ln(C0/Ct) vs. time. In addition, chemical oxygen demand (COD) tests were performed on RA solution before and after photodegradation, showing a COD reduction of ~85% (from 19.8 to 3 mg O2·L−1), which corroborates mineralization beyond chromophore bleaching. Under [C0 = 20 mg·L−1] and [mcat = 1.0 g·L−1], CeO2 achieved [RA = 90% at 180 min, k = 0.0125 min−1]. These results demonstrate that CeO2 is an effective photocatalyst for RA degradation under UV-A irradiation, integrating adsorption, kinetic behavior, and mineralization performance into a coherent structure–property relationship.