Geovanny Benjamin Maldonado Seas

Mr. Geovanny Benjamin Maldonado Seas

orcid

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
Verified
Journal Article
Open access
PDF file
LLLuis Marcelo López-López
Luis Marcelo López-López
GSGeovanny Benjamin Maldonado Seas
Geovanny Benjamin Maldonado Seas
César A. PaltánCésar A. Paltán
César A. Paltán
Jimmy Ricardo Brito MorochoJimmy Ricardo Brito Morocho
Jimmy Ricardo Brito Morocho
Julio Loja QuezadaJulio Loja Quezada
Julio Loja Quezada
MAMarco Amaya
Marco Amaya
Traditional manufacturing processes yield plastic containers in large batches, even for minimal production runs, resulting in elevated production costs. Three-dimensional printing has emerged as a viable alternative for very low production volumes, offering properties comparable to traditional methods at significantly reduced costs. To assess the tensile strength, specimens printed with identical geometric parameters to the 3D-printed containers were tested according to ASTM D638 standards, enabling the determination of the stress–strain curve behavior. A compression test was conducted on containers obtained from both manufacturing processes to establish their respective resistance and deformation characteristics. The results revealed a 67% difference in resistance, indicating greater rigidity in the 3D-printed container, and a higher deformation in the blow-molded container, reaching up to 4 mm in height without fracture. Similarly, impact resistance was analyzed using finite element analysis with Ls-Dyna software, showing deformation differences of 0.91% and stress differences of 2.15%. Therefore, 3D printing presents itself as a compelling alternative for the fabrication of plastic containers in small production runs.