Triboelectric nanogenerators (TENGs) are used as self-power sources for various types of devices by converting external waves, wind, or other mechanical energies into electric power. However, obtaining a high-output performance is still of major concern for many applications. In this study, to enhance the output performance of polydimethylsiloxane (PDMS)-based TENGs, highly dielectric TiO2−x nanoparticles (NPs) were embedded as a function of weight ratio. TiO2−x NPs embedded in PDMS at 5% showed the highest output voltage and current. The improved output performance at 5% is strongly related to the change of oxygen vacancies on the PDMS surface, as well as the increased dielectric constant. Specifically, oxygen vacancies in the oxide nanoparticles are electrically positive charges, which is an important factor that can contribute to the exchange and trapping of electrons when driving a TENG. However, in TiO2−x NPs containing over 5%, the output performance was significantly degraded because of the increased leakage characteristics of the PDMS layer due to TiO2−x NPs aggregation, which formed an electron path.
8 July 2021 in IEEE Transactions on Electron Devices
Simultaneous ultraviolet and thermal treatments (SUTs) enhanced the stability of tungsten-doped indium zinc oxide (W-IZO) thin-film transistor (TFT) compared to the furnace-annealed W-IZO TFT. To understand the change in electrical device instability, we used the in-situ measurement under the gate bias stress to investigate the electronic structure of active layer in actual TFT device. The physical properties of the active layer in the actual TFT structure, such as the unoccupied states in the conduction band and the band edge states below the conduction band, are related to the defect states of the oxide material and show the behavior of charge trapping. Improvement of the device stability mainly comes about from dynamic changes in the electron trap site in the channel region. The in-situ analysis, the relative conduction band area, and the band edge states for SUT-treated W-IZO active layer are much less changed under the gate bias stress than the furnace annealed W-IZO active layer.