Interior Permanent Magnet Synchronous Motors (IPMSMs) are widely used in the electrification sector; however, reliance on rare-earth magnets imposes constraints stemming from supply instability and mining-related environmental impacts, raising sustainability concerns. To address these issues, this study investigates an IPMSM employing a consequent pole (CP) structure, in which one permanent magnet pole is replaced by iron. Because flux asymmetry in CP IPMSMs can cause torque ripple and associated vibration and noise, we propose an Intersect Consequent Pole (ICP) rotor geometry and evaluate it against a conventional IPMSM under identical stator conditions. The proposed ICP topology reduces permanent magnet usage and provides a rare-earth-reduced design alternative that addresses the vibration/noise trade-off, with a particular focus on electric power steering (EPS) applications. Electromagnetic characteristics and performance were analyzed using finite element analysis (FEA) and verified via FEA-based comparisons.

This study proposes a multi-via structure as a loss-reduction design technique to mitigate current crowding in a slotless axial flux permanent magnet motor (AFPM) equipped with printed circuit board (PCB) stators. The PCB stator enables high current density operation through parallel copper-foil stacking and supports an ultra-compact structural configuration. However, current concentration in the via regions can increase copper loss and phase resistance. In this work, the via position and diameter were defined as design variables to perform a sensitivity analysis of current distribution and phase resistance variation. The effects of current density dispersion and the potential for copper loss reduction were evaluated using three-dimensional finite-element analysis (FEA). The results confirm that adopting a multi-via structure improves current path uniformity and reduces electrical losses, thereby enhancing overall efficiency. Furthermore, the analysis shows that excessive via enlargement or overuse does not necessarily yield optimal results and, in certain cases, may lead to localized current peaks. These findings demonstrate that the multi-via structure is an effective and appropriate design strategy for PCB stators and highlight the importance of optimized via placement tailored to each stator configuration.

Recently, the demand for electric motors that can achieve high performance while ensuring stable magnet supply has continued to increase across various industrial sectors. Although rare-earth permanent magnets, such as neodymium and samarium cobalt, enable superior electromagnetic performance, their high cost and supply instability have motivated growing interest in motors employing non-rare-earth permanent magnets, such as ferrite magnets. Due to the relatively low remanent flux density and coercivity of non-rare-earth magnets, spoke-type rotor structures are commonly adopted to enhance flux concentration. However, spoke-type configurations inherently suffer from axial leakage flux, in which a portion of the magnetic flux generated by the permanent magnets fails to link with the stator and instead leaks along the axial direction. This axial leakage flux reduces the effective air-gap flux density, leading to a degradation of back electromotive force (back-EMF) and overall motor performance. In this study, a double-spoke-type motor employing asymmetric permanent magnet geometry is investigated. Finite element analysis (FEA) is performed to identify an effective rotor structure that reduces axial leakage flux without increasing magnet usage, demonstrating the feasibility of performance improvement in non-rare-earth permanent magnet motors.

This paper proposes a design and control process for a dual-phase motors (DPM) aimed at independent drive. To achieve independent drive, different pole numbers are used for the inner rotor and outer rotor of the dual-rotor motors (DRM). Additionally, a special winding method is selected to allow the inner rotor and outer rotor to operate independently on a single stator. Through this winding method, only the rotor linked to the current is driven. The motor uses a combined current synthesized from 3-phase and 6-phase currents, and so the current ratio and period based on electrical frequency are determined. By selecting the current ratio, a current similar to the phase voltage waveform is formed to find the optimal output point, which is then formalized. Furthermore, by redefining the period, the inner rotor and outer rotor are analyzed separately within the complex waveform. Subsequently, the motor’s T-N curve characteristics are analyzed through voltage/current limit circles, and the control method is explained to present the overall process of the DPM.