Natural gas stands out as a promising alternative fuel, and utilizing late intake valve close (LIVC) can further enhance its potential by improving internal combustion engine performance. The present study investigated the effect of LIVC on the performance of a Nissan Qashqai J10 four-cylinder internal combustion ignition engine (ICE) operating on gasoline (G) and natural gas (NG), with a focus on both energy and ecological aspects at stoichiometric points. Experimental tests were performed under the usual engine operating conditions, with engine speeds of 2000 and 3000 rpm and brake mean effective pressures (BMEPs) of 0.31, 0.55, and 0.79 MPa, while the intake valve closing moment was delayed at 24°, 31°, 38°, 45°, 52°, and 59° after bottom dead center (aBDC). The software AVL BOOST™ (version R2021.2) and its utility BURN were used to calculate the rate of heat release (ROHR), mass fraction burned (MFB), in-cylinder temperature, and the rate of temperature rise. The substitution of natural gas for gasoline substantially decreases CO₂ and NO_x emissions while enhancing the engine’s energy efficiency. Implementing a LIVC strategy can further boost brake thermal efficiency and reduce CO₂, though it negatively impacts CO, HC, and NO_x emissions. Optimal performance necessitates balancing efficiency improvements and CO₂ reduction against the control of other pollutants, potentially through combining LIVC with alternative engine control methodologies.

Hybrid electric vehicles (HEVs) frequently cycle their internal combustion engines (ICE), potentially cooling the three-way catalyst (TWC). This challenges the use of compressed natural gas (CNG), as methane (CH₄) requires high temperatures for TWC oxidation. This study experimentally investigates the performance, engine-out emissions (CO, NO_x, CH₄, NMHC, CO₂), and catalyst temperatures of a Toyota RAV4 hybrid vehicle on gasoline (G), CNG, and dual fuel (MIX) during the WLTC. Engine-out emissions were measured upstream of the TWC. Results showed similar engine work output (~17.8 kWh/100 km), while CNG significantly reduced fuel mass consumption (−18.7%) and CO₂ emissions (−27.5%) compared to gasoline, driven by both its higher LHV and higher average BTE. CO (−32.3%) and NO_x (−34.0%) emissions were lower with CNG, linked to leaner operation and significantly retarded ignition timing for NO_x control. However, CH₄ emissions drastically increased with CNG. This study reveals a synergy between the same retarded ignition timing strategy used to successfully control engine-out NO_x (−34.0%) and created a positive secondary effect, raising pre-TWC temperatures by 4.5%. Higher thermal condition is essential for the aftertreatment of chemically stable methane, highlighting a direct link between the engine’s NO_x control logic and the potential to mitigate methane slip.

When a new vehicle is being created or developed, many technical parameters that affect dynamic characteristics must be investigated not only on a theoretical level, but also by natural experiments. Especially one of the most important characteristics for a vehicle that can tilt is tire–road contact, which later helps to calculate and simulate different driving conditions in different driving scenarios, applying internal and external forces. This paper presents a unique construction of a three-wheeled tilting vehicle prototype, tire–road contact determination, and evaluation of vehicle behaviour using the Pacejka tire model. To achieve this, the tire and road surface area were investigated. Using the computed method, experimentally determined contact areas were refined and compared with the actual measured. Determined tire–road contact areas were evaluated by applying dynamic external forces for further investigation. Selected a scenario to predict the behavior of a three-wheeled tilting vehicle and the force distribution during tilting, then determined certain vehicle parameters in the static position (load distribution, tire–road contact areas). The inclusion of asymmetric front-left and front-right tire loads under tilt resulted in observable differences in force distribution. The inner front tire unloaded while the outer tire gained load, introducing asymmetry in both lateral and longitudinal forces. This behaviour was not captured in the symmetric model.