High-purity scandium oxide is the principal raw material of high-purity scandium metal and aluminum scandium alloy targets for electronic materials. The performance of electronic materials will be significantly impacted by the presence of trace amounts of radionuclides due to the increase in free electrons. However, about 10 ppm of Th and 0.5–20 ppm of U are typically present in commercially available high-purity scandium oxide, which it is highly necessary to remove. It is currently challenging to detect trace impurities in high-purity scandium oxide, and the detection range of trace thorium and uranium is relatively high. Therefore, it is crucial to develop a technique that can accurately detect trace Th and U in high concentrations of scandium solution in the research on high-purity scandium oxide quality detection and the removal of trace impurities. This paper adopted some advantageous initiatives to develop a method for the inductively coupled plasma optical emission spectrometry (ICP-OES) determination of Th and U in high-concentration scandium solutions, such as spectral line selection, matrix influence analysis, and spiked recovery. The reliability of the method was verified. The relative standard deviations (RSD) of Th is less than 0.4%, and the RSD of U is less than 3%, indicating that this method has good stability and high precision. This method can be used for the accurate determination of trace Th and U in high Sc matrix samples, which provides an effective technical support for the preparation of high purity scandium oxide, and supports the production of high-purity scandium oxide.
The precipitation process of rare earth from a rare earth chloride solution using magnesium bicarbonate yields a dilute magnesium chloride (MgCl2) solution. The dilute MgCl2 solution can only be concentrated to a maximum concentration of about 70 g/L by conventional reverse osmosis (RO), which is insufficient for recycling. Low-salt-rejection reverse osmosis (LSRRO) allows for a higher concentration of brine while operating at moderate pressures. However, research on LSRRO for the concentration of MgCl2 solution is still at an initial stage. In this study, polyamide RO membranes were treated with sodium hypochlorite (NaClO) to prepare low-salt-rejection membranes. The effects of NaClO concentration, pH, and chlorination time on the membrane properties were investigated. Under alkaline chlorination conditions, the membrane’s salt rejection decreased, and water flux increased with increasing NaClO concentration and chlorination time. This can be explained by the hydrolysis of polyamide in the alkaline solution to form carboxylic acids and amines, resulting in a decrease in the crosslinking degree of polyamide. The low-salt-rejection membrane was prepared by exposing it to a NaClO solution at a concentration of 15 g/L and a pH of 11 for 3 h, and the salt rejection of MgCl2 was 50.7%. The MgCl2 solution with a concentration of 20 g/L was concentrated using multi-stage LSRRO at the pressure of 5 MPa. The concentration of the concentrated brine reached 120 g/L, which is 87% higher than the theoretical maximum concentration of 64 g/L for conventional RO at the pressure of 5 MPa. The specific energy consumption (SEC) was 4.17 kWh/m3, which decreased by about 80% compared to that of mechanical vapor recompression (MVR). This provides an alternative route for the efficient concentration of a diluted MgCl2 solution with lower energy consumption.
To address the issues of high wastewater treatment costs and the lack of recycling associated with conventional precipitants such as oxalic acid and ammonium bicarbonate in rare earth precipitation processes, this study proposes a novel gradient alkali conversion–carbonation method based on a green process coupling “rare earth chloride alkali conversion-carbonation with sodium chloride electrolysis.” The primary scientific objective is to elucidate the crystallization mechanism and to achieve controlled preparation of high-quality lanthanum carbonate. By gradient-controlling the addition sequence and rate of alkali liquor and CO2, lanthanum carbonate tetrahydrate was successfully synthesized. Characterization by XRD, SEM, ICP, and laser particle size analysis indicates that the product prepared by the gradient alkali conversion–carbonation method exhibits a single phase with high crystallinity, as evidenced by sharp and clear XRD diffraction peaks. Furthermore, the median particle size of the product obtained via this method is relatively large, reaching approximately 10 μm, while the particle size distribution Span value remains around 1.0. Mechanistic studies suggest that this method effectively regulates the crystallization process by precisely controlling the introduction and slow dissolution of the La(OH)3 precursor, thereby reducing the supersaturation of the system during carbonation and facilitating the dissolution–reprecipitation of La3+. This work provides a theoretical basis for the preparation of high-quality rare earth carbonates and a process reference for the green recycling route.