An ultrasonic treatment was used to ensure that the nano zinc oxide abbreviated ZnO, was uniformly dispersed throughout the cement paste mixture with addition of fly ash, replacing 10% of the weight of cement. The characteristics of the cementitious mixture were investigated in this research work. The experimental work was carried out by adding nano-ZnO in increments of 0%, 0.25%, 0.5%, 0.75% and 1% by weight of cement, resulting in changes in the characteristics of the concrete paste. The quantity of nano-ZnO present in the cementitious mixture had a notable influence on the consistency of the cement. This impact was also found when the cement paste contained only 0.5% cement by weight. The electrical resistance studies found that the inclusion of nano-sized particles can both delay the hydration of blended cement mix and increase the hydration rate. The findings of experiments revealed that increasing the nano-ZnO concentrations in the cement paste resulted in greater long-term strength. Furthermore, the pore diameter distribution was optimized by the inclusion of nano-ZnO and a tight microstructure was formed in the cementitious mixture at 28 days.
The Design of Experiment (DOE) technique was used to assess the impact of factors such as silica fume, bamboo fibers, and jute fibers on concrete strength. The Box–Behnken design of Response Surface Methodology (RSM) identified the optimal combination of variables and their effects on split tensile and compressive strength at 14 and 28 days. Pareto charts and Analysis of Variance (ANOVA) were used to analyze regression models for these responses. In this study, the jute and bamboo fibers with Silica Fume mixed concrete (each 0.5%) provides the maximum compressive strength of 30.27 MPa and split tensile strength of 3.19 MPa after 28 days of curing. After determining each progression variable’s statistical significance, second-order polynomials were used to create the resulting models. The quality of concrete strength was increased by adding bamboo and jute fibers along with silica fume and further addition of these fibers may reduce the strength of the concrete. The Response Surface and Pareto chart recommended the most significant and influential element for spilt tensile strength is jute and bamboo fibers, and for compressive strength is a jute fiber. Regarding split and compressive strength, the validation test percentage error is less than 3% and 4%, respectively.
The growing influence of green building materials has increased the pace in terms of utilizing industrial byproducts like fly ash as alternative materials to the normal clay bricks in construction. This study provides an elaborate experimental study of the fly‐ash‐foam bricks with the aim of reducing environmental challenges posed by the brick manufacturing processes that are energy and carbon‐demanding. This paper investigates how the proportion of different fly ash and foaming agents affects these key performance parameters: compressive strength, water absorption, efflorescence, and dry density. Results show that when a 1:2 mix ratio was used without a foaming agent, the compressive strength peaked at 10.595 N/mm 2 , and the compressive strength was lower at 5.43 N/mm 2 when a foaming agent was added because of higher internal porosity. Water absorption was also increased in the presence of the foaming agent to 12.75% in foamed mixes as compared to 3.55% in unfoamed specimens. Furthermore, the dry density of wet mix had dropped to 1482.2 and 938.7 kg/m 3 in the dense mix and the 1:4 foamed mix, respectively, with an intermediate increase in efflorescence. These findings carry an importance of balancing the blend composition to achieve a balance between low weight and sufficient mechanical integrity, and advance the use of fly‐ash‐based foam bricks as a feasible, sustainable material in modern construction activities.