A new isolated current-fed zero-current switched (ZCS) front-end DC/DC converter based multilevel inverter is proposed for multi-input application. The proposed front end converter with only two controllable switches integrates two different renewable energy sources, resulting into a advantageous compact structure and low conduction losses. The ZCS turn off is achieved in both the controllable switches with proposed modulation scheme. The converter maintains ZCS turn off under a wide load as well as input voltage variations by employing frequency modulation along with variable duty ratio technique. Simple structure, soft switching, high gain and automatic load regulation makes the converter structure novel for simultaneous power management in multi-input renewable energy applications. Converter operation and design guide lines have been outlined. A laboratory prototype of the proposed converter is developed and tested at 300-Watt power level. Simulations and experimental results demonstrate the robust performance under load as well as input source voltage variationswitches with proposed modulation scheme. The converter maintains ZCS turn off under a wide load as well as input voltage variations by employing frequency modulation along with variable duty ratio technique. Simple structure, soft switching, high gain and automatic load regulation makes the converter novel for simultaneous power management in multi-input renewable energy applications. Converter operation and design guide lines have been outlined. A laboratory prototype of the proposed converter is developed and tested at 300 Watt power level. Simulations and experimental results demonstrate the robust performance under load as well as input source voltage variation
7 May 2020 in IEEE Transactions on Industrial Electronics
A high gain non-isolated dc—dc converter is proposed for the distributed generation systems. High voltage gain is achieved by integrating different methods with reduced duty ratio. Inductive voltage spikes across MOSFETs are alleviated and stress is reduced with inclusion of a passive-clamp circuit. Thus, lower voltage rating (small Rds(ON)) active devices can be adopted. Using this clamp, zero - voltage switching (ZVS) over wide load range is achieved for both the MOSFETs. In addition, leakage-energy of the coupled inductor is recycled without use of auxiliary witch and thus, the gain get further improved. Zero - current switching (ZCS) is obtained for all the diodes using quasi-resonance principle, which diminish voltage spikes across the diode caused by the parasitic ringing between leakage inductance and diode's stray capacitance. Therefore, snubbers are not necessary to protect the diodes and to mitigate reverse-recovery losses. Overall efficiency improves because of lower switching and conduction losses of the semiconductor devices. A 600—W prototype working at 75 kHz is built in the laboratory to verify the performance. The peak efficiency is nearly 96.5% and is above 95% for wide load range.
21 October 2020 in IEEE Transactions on Industrial Electronics
A soft-switched modular non-isolated converter is proposed for distributed generation systems. By integrating flyback energy delivering circuit to the interleaved boost converter, ultra-high voltage gain and high efficiency are achieved with reduced duty ratio. Cockcroft-Walton(CW) based multiplier cell extensively reduces voltage stress on the active switches. Voltage spikes across MOSFETs caused by leakage inductance and interconnection of primary-secondary windings are alleviated by adjoining the active switch based auxiliary circuit. Thus, low voltage rating switches(small Rds(ON)) are employed. Further, the clamp circuit realizes wide-load-range ZVS turn-on and, reduced falling current magnitudes ensures low turn-off losses for all the MOSFTETs. Also, leakage-energy is recycled to the load. Indeed, leakage-energy effectively limits the rate of fall-current(dif/dt) through power diodes and alleviates the reverse-recovery problem by turning-off them with zero-current switching (ZCS). Further, during turn-on, ZVS is achieved for all the diodes. Thus, voltage spikes across the diodes are suppressed without needing any snubber. Minimized voltage stresses, lowered on-state and switching losses of the semiconductor devices, altogether, improves the efficiency. A 600W prototype working at 100 kHz is developed in the laboratory to validate the design analysis. Measured efficiency at rated-load is 95.81% and maximum efficiency is 96.65%.
A new modified LCLC series resonant circuit based dual-input single out-put isolated converter is proposed for hybrid energy systems. With this novel converter topology, two different voltage sources can be decoupled completely and transfer the power from two separate dc sources to dc load simultaneously. The proposed converter consists only two controllable switches for integrating two separate voltage sources; it can provide good voltage regulation and soft switching over wide load range. During unequal input voltages, the converter continues to maintain soft-switching and voltage regulation. The proposed converter operation and design considerations are outlined. A laboratory prototype rated for 250 Watt power at an output voltage of 380 V was built-up and tested. Experimental results confirm the functionality of the converter in terms of voltage regulation and soft switching over a wide load range.
5 July 2019 in Journal of Circuits, Systems and Computers