Xianjie Zhou

Dr. Xianjie Zhou


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 November 2025 in Micromachines
Verified
Journal Article
Open access
PDF file
XZXianjie Zhou
Xianjie Zhou
QZQiming Zeng
Qiming Zeng
LGLi Guo
Li Guo
YYYicheng Yu
Yicheng Yu
FYFei Yu
Fei Yu
YXYan Xue
Yan Xue
Gate driver-on-array (GOA) circuits employing amorphous indium–gallium–zinc oxide (IGZO)-based thin-film transistors (TFTs) have been successfully utilized to generate the driving signals for the commercialization of active-matrix organic light-emitting diode (AMOLED) displays. The depletion-mode TFTs in GOA circuits can be completely turned off by the introduction of series-connected, two-transistor, dual low-voltage-level power signals. Simulation results demonstrate that a GOA exhibits high process stability with a threshold voltage margin from −5 V to +5 V. Furthermore, the GOA output characterization and mobility compensation effect are evaluated by the integration of the GOA and pixel in a 31-inch 4K AMOLED display. Experimental results demonstrate that full-swing driving pulses can be obtained with the GOA. Finally, the stripe mura in the display caused by mobility variation can be successfully eliminated by the introduction of GOA circuits.

26 October 2022 in Coatings
Verified
Journal Article
Open access
PDF file
XZXianjie Zhou
Xianjie Zhou
HXHanqing Xiong
Hanqing Xiong
JXJiwen Xu
Jiwen Xu
The sintering process of the MoOx target has an impact on the quality of the sputtered film. In this study, powders of MoO3 (78 wt%) and MoO2 (22 wt%) were milled and hot-pressed to prepare the MoOx target. The effects of the sintering temperature of the MoOx targets on the properties of the sputtered MoOx films were investigated by X-ray diffraction, scanning electron microscopy, four-probe needle, and spectrophotometer tests. The research results revealed that the MoOx target at the sintered temperature of 1000 °C had a clear crystal structure and dense grains, exhibiting good sinterability, crystallization behavior, and film-forming property. The sputtered film deposited by the MoOx target could obtain high quality with a smooth interface and uniform thickness. The film had smaller resistivity, higher reflectivity, and appropriate transmissivity compared to the ones fabricated by other targets that were sintered at 800 °C, 900 °C, and 1100 °C.

16 October 2025 in Preprints.org
Verified
Preprint
Open access
PDF file
XZXianjie Zhou
Xianjie Zhou
QZQiming Zeng
Qiming Zeng
LGLi Guo
Li Guo
YYYicheng Yu
Yicheng Yu
FYFei Yu
Fei Yu
YXYan Xue
Yan Xue
A gate driver on array (GOA) circuits employed with amorphous indium-gallium-zinc oxide (IGZO) based thin film transistors (TFTs) have been successfully utilized to generate the driving signals for the commercialization of active matrix organic light-emitting diode (AMOLED) displays. The depletion-mode TFTs in GOA circuits can be completely turned off by the introduction of series-connected two-transistor and dual low voltage level power signals. Simulation results demonstrate that GOA exhibits high process stability with threshold voltage margin from -5V to +5V. Furthermore, GOA output characterization and mobility compensation effect are evaluated by the integration of GOA and pixel in a 31-inch 4K AMOLED display. Experimental results demonstrate that full swing driving pulses can be obtained by GOA. Finally, the stripe mura in display caused by mobility variation can be successfully eliminated by the introduction of GOA circuits.

18 October 2025 in Ceramics
Verified
Journal Article
Open access
PDF file
JLJuan Li
Juan Li
JXJiwen Xu
Jiwen Xu
GZGuisheng Zhu
Guisheng Zhu
XZXianjie Zhou
Xianjie Zhou
FSFei Shang
Fei Shang
HXHuarui Xu
Huarui Xu
NiO-based hole-transport layers are crucial for high-efficiency perovskite solar cells. An industrial deposition method of NiO films is magnetron sputtering using ceramic targets. NiO targets doped with Li contents at 1%, 3%, and 5% were designed, and the doping contents and sintering temperatures were investigated. All the targets have a face-centered cubic phase, dense microstructure, and an average size of a few microns. The NLO targets sintered at an optimal temperature of 1400 °C exhibited high relative density (>98%) and low resistivity (<6 Ω∙cm). These results pave the way for depositing NiO-based hole-transport layer by magnetron sputtering.