Jonathan Fenton

Dr. Jonathan Fenton

orcid

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 April 2013 in Physical Review B
Verified
Journal Article
Closed access
CWC. H. Webster
C. H. Webster
JFJonathan Fenton
Jonathan Fenton
THT. T. Hongisto
T. T. Hongisto
SGS. P. Giblin
S. P. Giblin
AZA. B. Zorin
A. B. Zorin
PWP. A. Warburton
P. A. Warburton
We present a detailed report of microwave irradiation of ultranarrow superconducting nanowires. In our nanofabricated circuits containing a superconducting NbSi nanowire, a dc blockade of current flow was observed at low temperatures below a critical voltage ${V}_{\mathrm{c}}$, a strong indicator of the existence of quantum phase-slip (QPS) in the nanowire. We describe the results of applying microwaves to these samples, using a range of frequencies and both continuous-wave and pulsed drive, in order to search for dual Shapiro steps which would constitute an unambiguous demonstration of quantum phase-slip. We observed no steps, and our subsequent thermal analysis suggests that the electron temperature in the series CrO resistors was significantly elevated above the substrate temperature, resulting in sufficient Johnson noise to wash out the steps. To understand the system and inform future work, we have constructed a numerical model of the dynamics of the circuit for dc and ac bias (both continuous-wave and pulsed drive signals) in the presence of Johnson noise. Using this model, we outline important design considerations for device and measurement parameters which should be used in any future experiment to enable the observation of dual Shapiro steps at experimentally accessible temperatures and, thus, lead to the development of a QPS-based quantum current standard.

31 July 2017 in Physical Review Applied
Verified
Journal Article
Open access
PDF file
JBJ. Burnett
J. Burnett
JSJ. Sagar
J. Sagar
OKO. W. Kennedy
O. W. Kennedy
PWP. A. Warburton
P. A. Warburton
JFJonathan Fenton
Jonathan Fenton
We present low-temperature measurements of low-loss superconducting nanowire-embedded resonators in the low-power limit relevant for quantum circuits. The superconducting resonators are embedded with superconducting nanowires with widths down to 20 nm using a neon focused ion beam. In the low-power limit, we demonstrate an internal quality factor up to 3.9×105 at 300 mK [implying a two-level-system-limited quality factor up to 2×105 at 10 mK], not only significantly higher than in similar devices but also matching the state of the art of conventional Josephson-junction-embedded resonators. We also show a high sensitivity of the nanowire to stray infrared photons, which is controllable by suitable precautions to minimize stray photons in the sample environment. Our results suggest that there are excellent prospects for superconducting-nanowire-based quantum circuits.

27 August 2008 in Physical Review B
Verified
Journal Article
Closed access
PDF file
JFJonathan Fenton
Jonathan Fenton
PWP. A. Warburton
P. A. Warburton
A crossover at a temperature T∗ in the temperature dependence of the width σ of the distribution of switching currents of moderately damped Josephson junctions has been reported in a number of recent papers, with positive dσ/dT and IV characteristics associated with underdamped behavior for lower temperatures T<T∗ and negative dσ/dT and IV characteristics resembling overdamped behavior for higher temperatures T>T∗. We have investigated in detail the behavior of Josephson junctions around the temperature T∗ by using Monte Carlo simulations including retrapping from the running state into the supercurrent state as given by the model of Ben-Jacob et al. [Phys. Rev. A 26, 2805 (1982)]. We develop discussion of the important role of multiple escape and retrapping events in the moderate-damping regime, in particular considering the behavior in the region close to T∗. We show that the behavior is more fully understood by considering two crossover temperatures and that the shape of the distribution and σ(T) around T∗, as well as at lower T<T∗, are largely determined by the shape of the conventional thermally activated switching distribution. We show that the characteristic temperatures T∗ are not unique for a particular Josephson junction but have some dependence on the ramp rate of the applied bias current. We also consider hysteresis in moderately damped Josephson junctions and discuss the less commonly measured distribution of return currents for a decreasing current ramp. We find that some hysteresis should be expected to persist above T∗. We highlight the importance, even well below T∗, of accounting properly for thermal fluctuations when determining the damping parameter Q.

16 June 2018 in Nanomaterials
Verified
Journal Article
Open access
PDF file
NCNicolas G. N. Constantino
Nicolas G. N. Constantino
MAMuhammad Shahbaz Anwar
Muhammad Shahbaz Anwar
OKOscar Kennedy
Oscar Kennedy
MDManyu Dang
Manyu Dang
PWPaul A. Warburton
Paul A. Warburton
JFJonathan Fenton
Jonathan Fenton
Superconducting nanowires undergoing quantum phase-slips have potential for impact in electronic devices, with a high-accuracy quantum current standard among a possible toolbox of novel components. A key element of developing such technologies is to understand the requirements for, and control the production of, superconducting nanowires that undergo coherent quantum phase-slips. We present three fabrication technologies, based on using electron-beam lithography or neon focussed ion-beam lithography, for defining narrow superconducting nanowires, and have used these to create nanowires in niobium nitride with widths in the range of 20–250 nm. We present characterisation of the nanowires using DC electrical transport at temperatures down to 300 mK. We demonstrate that a range of different behaviours may be obtained in different nanowires, including bulk-like superconducting properties with critical-current features, the observation of phase-slip centres and the observation of zero conductance below a critical voltage, characteristic of coherent quantum phase-slips. We observe critical voltages up to 5 mV, an order of magnitude larger than other reports to date. The different prominence of quantum phase-slip effects in the various nanowires may be understood as arising from the differing importance of quantum fluctuations. Control of the nanowire properties will pave the way for routine fabrication of coherent quantum phase-slip nanowire devices for technology applications.

9 December 2014 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
CNC. R. Nash
C. R. Nash
JFJonathan Fenton
Jonathan Fenton
NCN. G. N. Constantino
N. G. N. Constantino
PWP. A. Warburton
P. A. Warburton
We report on the electrical characterisation of a series of thin amorphous chromium oxide (CrOx) films, grown by dc sputtering, to evaluate their suitability for use as on-chip resistors in nanoelectronics. By increasing the level of oxygen doping, the room-temperature sheet resistance of the CrOx films was varied from 28 Ω/◻ to 32.6 kΩ/◻ . The variation in resistance with cooling to 4.2 K in liquid helium was investigated; the sheet resistance at 4.2 K varied with composition from 65 Ω/◻ to above 20 GΩ/◻ . All of the films measured displayed linear current–voltage characteristics at all measured temperatures. For on-chip devices for quantum phase-slip measurements using niobium–silicon nanowires, interfaces between niobium–silicon and chromium oxide are required. We also characterised the contact resistance for one CrOx composition at an interface with niobium–silicon. We found that a gold intermediate layer is favourable: the specific contact resistivity of chromium-oxide-to-gold interfaces was 0.14 mΩcm2, much lower than the value for direct CrOx to niobium–silicon contact. We conclude that these chromium oxide films are suitable for use in nanoscale circuits as high-value resistors, with resistivity tunable by oxygen content.

21 February 2012 in Nanotechnology
Verified
Journal Article
Open access
WLWuxia Li
Wuxia Li
JFJonathan Fenton
Jonathan Fenton
ACAjuan Cui
Ajuan Cui
HWHuan Wang
Huan Wang
YWYiqian Wang
Yiqian Wang
PWP A Warburton
P A Warburton
We report that, to enable studies of their compositional, structural and electrical properties, freestanding individual nanoobjects can be selectively felled in a controllable way by the technique of low-current focused-ion-beam (FIB) milling with the ion beam at a chosen angle of incidence to the nanoobject. To demonstrate the suitability of the technique, we report results for zigzag/straight tungsten nanowires grown vertically on support substrates and then felled for characterization. We also describe a systematic investigation of the effect of the experimental geometry and parameters on the felling process and on the induced wire-bending phenomenon. The method of felling freestanding nanoobjects using FIB is an advantageous new technique enabling investigations of the properties of selected individual nanoobjects.