We report on measurements of supercurrents through the half-metallic ferromagnet CrO2 grown on hexagonal Al2O3 (sapphire). The current was observed to flow over a distance of 700 nm between two superconducting amorphous Mo70Ge30 electrodes which were deposited on the CrO2 film. The critical current Ic increases as function of decreasing temperature. Upon applying an in-plane magnetic field, Ic goes through a maximum at the rather high field of 80 mT. We believe this to be a long-range proximity effect in the ferromagnet, carried by odd-frequency pairing correlations.
There is strong experimental evidence that the superconductor has a chiral -wave order parameter. This symmetry does not require that the associated gap has nodes, yet specific heat, ultrasound, and thermal conductivity measurements indicate the presence of nodes in the superconducting gap structure of . Theoretical scenarios have been proposed to account for the existence of deep minima or accidental nodes (minima tuned to zero or below by material parameters) within a -wave state. Other scenarios propose chiral -wave and -wave states, with horizontal and vertical line nodes, respectively. To elucidate the nodal structure of the gap, it is essential to know whether the lines of nodes (or minima) are vertical (parallel to the tetragonal axis) or horizontal (perpendicular to the axis). Here, we report thermal conductivity measurements on single crystals of down to 50 mK for currents parallel and perpendicular to the axis. We find that there is substantial quasiparticle transport in the limit for both current directions. A magnetic field immediately excites quasiparticles with velocities both in the basal plane and in the direction. Our data down to and down to show no evidence that the nodes are in fact deep minima. Relative to the normal state, the thermal conductivity of the superconducting state is found to be very similar for the two current directions, from to . These findings show that the gap structure of consists of vertical line nodes. This rules out a chiral -wave state. Given that the -axis dispersion (warping) of the Fermi surface in varies strongly from sheet to sheet, the small anisotropy suggests that the line nodes are present on all three sheets of the Fermi surface. If imposed by symmetry, vertical line nodes would be inconsistent with a -wave order parameter for . To reconcile the gap structure revealed by our data with a -wave state, a mechanism must be found that produces accidental line nodes in .
E report measurements of long ranged supercurrents through ferromagnetic and fully spin-polarized CrO$_2$ deposited on TiO$_2$ substrates. In earlier work, we found supercurrents in films grown on sapphire but not on TiO$_2$. Here we employed a special contact arrangement, consisting of a Ni/Cu sandwich between the film and the superconducting amorphous Mo$_{70}$Ge$_{30}$ electrodes. The distance between the contacts was almost a micrometer, and we find the critical current density to be significantly higher than found in the films deposited on sapphire. We argue this is due to spin mixing in the Ni/Cu/CrO$_2$ layer structure, which is helpful in the generation of the odd-frequency spin triplet correlations needed to carry the supercurrent.Comment: 3 pages, 4 figure
Efforts have been ongoing to establish superconducting spintronics utilizing ferromagnet/superconductor heterostructures. Previously reported devices are based on spin-singlet superconductors (SSCs), where the spin degree of freedom is lost. Spin-polarized supercurrent induction in ferromagnetic metals (FMs) is achieved even with SSCs, but only with the aid of interfacial complex magnetic structures, which severely affect information imprinted to the electron spin. Use of spin-triplet superconductors (TSCs) with spin-polarizable Cooper pairs potentially overcomes this difficulty and further leads to novel functionalities. Here, we report spin-triplet superconductivity induction into a FM SrRuO3 from a leading TSC candidate Sr2RuO4, by fabricating microscopic devices using an epitaxial SrRuO3/Sr2RuO4 hybrid. The differential conductance, exhibiting Andreev-reflection features with multiple energy scales up to around half tesla, indicates the penetration of superconductivity over a considerable distance of 15 nm across the SrRuO3 layer without help of interfacial complex magnetism. This demonstrates potential utility of FM/TSC devices for superspintronics.
Non-reciprocal electronic transport in a material occurs if both time reversal and inversion symmetries are broken. The superconducting diode effect (SDE) is an exotic manifestation of this type of behavior where the critical current for positive and negative currents are mismatched, as recently observed in some non-centrosymmetric superconductors with a magnetic field. Here, we demonstrate a SDE in non-magnetic Nb/Ru/Sr2RuO4 Josephson junctions without applying an external magnetic field. The cooling history dependence of the SDE suggests that time-reversal symmetry is intrinsically broken by the superconducting phase of Sr2RuO4. Applied magnetic fields modify the SDE dynamically by randomly changing the sign of the non-reciprocity. We propose a model for such a topological junction with a conventional superconductor surrounded by a chiral superconductor with broken time reversal symmetry.
Superconducting nanowires undergoing quantum phase-slips have potential for impact in electronic devices, with a high-accuracy quantum current standard among a possible toolbox of novel components. A key element of developing such technologies is to understand the requirements for, and control the production of, superconducting nanowires that undergo coherent quantum phase-slips. We present three fabrication technologies, based on using electron-beam lithography or neon focussed ion-beam lithography, for defining narrow superconducting nanowires, and have used these to create nanowires in niobium nitride with widths in the range of 20–250 nm. We present characterisation of the nanowires using DC electrical transport at temperatures down to 300 mK. We demonstrate that a range of different behaviours may be obtained in different nanowires, including bulk-like superconducting properties with critical-current features, the observation of phase-slip centres and the observation of zero conductance below a critical voltage, characteristic of coherent quantum phase-slips. We observe critical voltages up to 5 mV, an order of magnitude larger than other reports to date. The different prominence of quantum phase-slip effects in the various nanowires may be understood as arising from the differing importance of quantum fluctuations. Control of the nanowire properties will pave the way for routine fabrication of coherent quantum phase-slip nanowire devices for technology applications.