The effect of forced cooling using heat sinks on the mechanical properties and interpass waiting time of two-pass welds has been studied for a martensitic steel with a yield strength of 960 MPa when the interpass temperature was 100 °C. Cross-weld tensile and − 40 °C Charpy-V impact toughness properties were examined. The use of heat sinks is shown to result in a beneficial increase of the cross-weld yield strength but at the expense of the yield-to-tensile strength ratio. Due to its particularly detrimental effect on the heat-affected zone (HAZ) toughness of multipass welds, special attention was given in the Charpy-V toughness of the intercritically reheated coarse-grained HAZ (ICCGHAZ) by also testing simulated ICCGHAZs. It is shown that forced cooling has a beneficial effect in respect of the toughness of this simulated subzone and on the Charpy-V toughness of the HAZ of the actual welds. The interpass cooling time during the two-pass welding was reduced by 37%. The results indicate that, in the case of high-strength steels, it may be possible to simultaneously improve both welding productivity and mechanical properties by using forced cooling down to 100 °C to reduce waiting time between weld passes.
We present computer simulations of austenite decomposition to ferrite and bainite during cooling. The phase transformation model is based on Johnson-Mehl-Avrami-Kolmogorov type equations. The model is parameterized by numerical fitting to continuous cooling data obtained with Gleeble thermo-mechanical simulator and it can be used for calculation of the transformation behavior occurring during cooling along any cooling path. The phase transformation model has been coupled with heat conduction simulations. The model includes separate parameters to account for the incubation stage and for the kinetics after the transformation has started. The incubation time is calculated with inversion of the CCT transformation start time. For heat conduction simulations we employed our own parallelized 2-dimensional finite difference code. In addition, the transformation model was also implemented as a subroutine in commercial finite-element software Abaqus which allows for the use of the model in various engineering applications.
In hot steel rolling processes, a slab is generally rolled to a transfer bar in a roughing process and to a strip in a hot strip rolling process. Over several rolling passes the front-end may bend upward or downward due to asymmetrical rolling conditions causing entry problems in the next rolling pass. Many different factors may affect the front-end bending phenomenon and are very challenging to measure. Thus, a customized finite element model is designed and built to simulate the front-end bending phenomenon in a hot strip rolling process. To simulate the functioning of the hot strip mill precisely, automated controlling logic of the mill must be considered. In this paper we studied the effect of roll bite friction conditions and amount of reduction on the front-end bending phenomenon in a hot strip rolling process.