When searching for the optimal solution, Equivalent Consumption Minimum Strategy (ECMS) has to calculate and compare the total equivalent fuel rate of huge candidates covered all over the control domain for each time instant. Therefore, this strategy still has a heavy computation burden problem; it is a challenge for ECMS to be implemented online for real-time control. To reduce ECMS’s calculation load, this paper proposes an adaptive Simplified-ECMS-based strategy for a parallel plug-in hybrid electric vehicle (PHEV). A convex piecewise function is applied to fit the total equivalent fuel rate with respect to the motor torque, which is the control variable. Then, the ECMS problem is simplified to calculate and compare only five candidates’ total equivalent fuel rate to determine the optimal torque distribution. Particle swarm optimization (PSO) algorithm is applied to optimize the equivalent factor, and the MAPs of this factor under different driving cycles, driving distances and initial SOC are obtained. Based on this, the adaptive Simplified-ECMS-based strategy is proposed. Simulations were performed, and the results show that the Simplified-ECMS-based strategy can obviously shorten the calculation time compared to ECMS-based strategy, and the adaptive Simplified-ECMS-based strategy can decrease fuel consumption of plug-in hybrid electric vehicle by 16.43% under the testing driving cycle, compared to CD-CS-based strategy. A road test on the prototype vehicle is conducted and the effectiveness of the Simplified-ECMS-based strategy is validated by the test data.
With plug-in hybrid electric vehicles (PHEVs), the catalyst temperature is below the light-off temperature due to reduced engine load, extended engine off period, and frequent engine on/off shifting. The conversion efficiency of a three-way catalyst (TWC) and tailpipe emissions were proven to depend heavily on the temperature of the catalyst. The existing energy management strategy (EMS) of the PHEVs focuses on the improvement of fuel efficiency and emissions based on hot engine characteristics, but neglects the effect of catalyst temperature on tailpipe emissions. This paper presents a new EMS that incorporates a catalyst thermal management method. First, an additional cost is established to implement additional constraints on catalyst temperature, and then the global cost function is created using this additional cost and the fuel consumption. Second, we find the global optimal solution using Pontryagin’s minimum principle method, which provides an optimal control policy and state trajectories. Then, based on the analysis of the optimal control policy, an engine on/off filter (eng on/off filter) is introduced to command the engine on/off shifting. This filter plays an important role in adjusting both the energy and catalyst thermal management strategy for PHEVs. Finally, a practical approach based on the eng on/off filter is developed, and a genetic algorithm is applied to optimize the time constants of this filter. Simulation results demonstrate that the proposed approach‘s fuel consumption increased slightly, but the tailpipe emissions of HC (hydrocarbons), CO (carbon monoxide) and NOx (nitrogen oxide) significantly decreased compared with the standard approach.
Driving mode switches of hybrid vehicles are significant events. Due to the different dynamic characteristics of the engine, motor, and wet clutch, it is difficult to coordinate torque fluctuations caused by mode switches. This paper focused on a control strategy for driving mode switches of plug-in hybrid electric vehicles (PHEVs) with a multi-disk wet clutch. First, the dynamic model of the PHEV was established, and a rule-based control strategy was proposed to divide the working mode regions and distribute the torque between engine and motor. Second, the dual fuzzy control strategy for a wet clutch and the coordinated torque control strategy for driving mode switches were proposed. The dual fuzzy logic control system consisted of the initial pulse-width modulation (PWM)’s duty cycle control and the changing rate of the PWM’s duty cycle control. Considering the difference in the dynamic characteristics between engine, motor, and wet clutch, a coordinated control strategy for the driving mode switches of PHEVs was put forward. Third, simulations of driving mode switches between pure electric driving mode and only engine driving mode were conducted. The results showed that the proposed control strategy could reduce the torque ripple and the jerk of the vehicle, completely satisfying the requirements of China. Finally, the control strategy for the motor-assisted engine starting process was tested on the bench. The experiment results indicated that the proposed control strategy was effective.