We demonstrate on-chip stimulated Brillouin scattering (SBS) in an As₂S₃ chalcogenide rib waveguide. SBS was characterized in a 7cm long waveguide with a cross-section 4μm x 850nm using the backscattered signal and pump-probe technique. The measured Brillouin shift and its full-width at half-maximum (FWHM) linewidth were ~7.7 GHz and 34 MHz, respectively. Probe vs. pump power measurements at the Brillouin shift were used to obtain the gain coefficient from an exponential fit. The Brillouin gain coefficient obtained was 0.715 x 10⁻⁹ m/W. A probe gain of 16 dB was obtained for a CW pump power of ~300 mW.

A fiber-optic temperature sensor based on the interference of selective higher-order modes in circular optical fibers is described. The authors demonstrate that by coupling the LP01 mode in a standard single-mode fiber to the LP0m modes in a multimode fiber, and utilizing the interference of the higher-order modes, a fiber-optic temperature sensor which has an extremely simple structure and is suitable for high-temperature measurements can be constructed. The sensing principle, temperature measurement experiments, and results are presented.

The Aharonov–Bohm effect is one of the most intriguing phenomena in both classical and quantum physics, and associates with a number of important and fundamental issues in quantum mechanics. The Aharonov–Bohm effects of charged particles have been experimentally demonstrated and found applications in various fields. Recently, attention has also focused on the Aharonov–Bohm effect for neutral particles, such as photons. Here we propose to utilize the photon–phonon interactions to demonstrate that photonic Aharonov–Bohm effects do exist for photons. By introducing nonreciprocal phases for photons, we observe experimentally a gauge potential for photons in the visible range based on the photon–phonon interactions in acousto-optic crystals, and demonstrate the photonic Aharonov–Bohm effect. The results presented here point to new possibilities to control and manipulate photons by designing an effective gauge potential.

We report the first demonstration of a photonic chip based dynamically reconfigurable, widely tunable, narrow pass-band, high Q microwave photonic filter (MPF). We exploit stimulated Brillouin scattering (SBS) in a 6.5 cm long chalcogenide (As₂S₃) photonic chip to demonstrate a MPF that exhibited a high quality factor of ~520 and narrow bandwidth and was dynamically reconfigurable and widely tunable. It maintained a stable 3 dB bandwidth of 23 ± 2MHz and amplitude of 20 ± 2 dB over a large frequency tuning range of 2-12 GHz. By tailoring the pump spectrum, we reconfigured the 3 dB bandwidth of the MPF from ~20 MHz to ~40 MHz and tuned the shape factor from 3.5 to 2 resulting in a nearly flat-topped filter profile. This demonstration represents a significant advance in integrated microwave photonics with potential applications in on-chip microwave signal processing for RADAR and analogue communications.

We report the first (to our knowledge) demonstration of photonic chip based tunable slow and fast light via stimulated Brillouin scattering. Slow, fast, and negative group velocities were observed in a 7 cm long chalcogenide (${\mathrm{As}}_2{\mathrm{S}}_3$) rib waveguide with a group index change ranging from $\sim -44$ to $+130$, which results in a maximum delay of $\sim 23\mathrm{ns}$ at a relatively low gain of $\sim 23\mathrm{dB}$. Demonstration of large tunable delays in a chip scale device opens up applications such as frequency sensing and true-time delay for a phased array antenna, where integration and delays $\sim 10\mathrm{ns}$ are highly desirable.