Biao Zhang

Dr. Biao Zhang


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 July 2024 in Nanomaterials
Verified
Journal Article
Open access
PDF file
JWJunjie Wen
Junjie Wen
YWYuankang Wang
Yuankang Wang
BZBiao Zhang
Biao Zhang
RCRongrong Chen
Rongrong Chen
HZHongyan Zhu
Hongyan Zhu
HXHongdi Xiao
Hongdi Xiao
The utilization of a nanoporous (NP) GaN fabricated by electrochemical etching has been demonstrated to be effective in the fabrication of a high-performance ultraviolet (UV) photodetector (PD). However, the NP-GaN PD typically exhibits a low light-dark current ratio and slow light response speed. In this study, we present three types of UV PDs based on an unetched GaN, NP-GaN distributed Bragg reflector (DBR), and NP-GaN-DBR with a Ga2O3 single-crystal film (Ga2O3/NP-GaN-DBR). The unetched GaN PD does not exhibit a significant photoresponse. Compared to the NP-GaN-DBR PD device, the Ga2O3/NP-GaN-DBR PD demonstrates a larger light-dark current ratio (6.14 × 103) and higher specific detectivity (8.9 × 1010 Jones) under 365 nm at 5 V bias due to its lower dark current (3.0 × 10−10 A). This reduction in the dark current can be attributed to the insertion of the insulating Ga2O3 between the metal and the NP-GaN-DBR, which provides a thicker barrier thickness and higher barrier height. Additionally, the Ga2O3/NP-GaN-DBR PD device exhibits shorter rise/decay times (0.33/0.23 s) than the NP-GaN-DBR PD, indicating that the growth of a Ga2O3 layer on the DBR effectively reduces the trap density within the NP-GaN DBR structure. Although the device with a Ga2O3 layer presents low photoresponsivity (0.1 A/W), it should be feasible to use Ga2O3 as a dielectric layer based on the above-mentioned reasons.

28 June 2025 in Materials
Verified
Journal Article
Open access
PDF file
XMXiaochen Ma
Xiaochen Ma
YLYuanheng Li
Yuanheng Li
XLXuan Liu
Xuan Liu
DCDeqiang Chen
Deqiang Chen
YLYong Le
Yong Le
BZBiao Zhang
Biao Zhang
Tantalum oxide is a wide bandgap material commonly used as an insulating dielectric layer for devices. In this work, hexagonal Ta2O5 (δ-Ta2O5) films doped with tungsten (W) were deposited on α-Al2O3 (0001) by metal–organic chemical vapor deposition (MOCVD). The effects of W doping on the structural, morphology, and photoelectrical properties of the obtained films were studied. The results showed that all W-doped films were n-type semiconductors. The XRD measurement result exhibited that the increase in the W doping concentration leads to the changes in the preferred growth crystal plane of the films from δ-Ta2O5 (101¯1) to (0001). The 1.5% W-doped film possessed the best crystal quality and conductivity. The Hall measurement showed that the minimum resistivity of the film was 2.68 × 104 Ω∙cm, and the maximum carrier concentration was 7.39 × 1014 cm3. With the increase in the W concentration, the surface roughness of the film increases, while the optical bandgap decreases. The optical band gap of the 1.5% W-doped film was 3.92 eV. The W doping mechanisms were discussed.

29 November 2024 in Materials Science in Semiconductor Processing
Verified
Journal Article
Closed access
HZHongyan Zhu
Hongyan Zhu
BZBiao Zhang
Biao Zhang
YWYuankang Wang
Yuankang Wang
CLCaina Luan
Caina Luan
JMJin Ma
Jin Ma
HXHongdi Xiao
Hongdi Xiao