A two-step electronic speckle pattern interferometry (ESPI) method with blind phase shift of a reference wave, in which the phase shift extraction is fulfilled by using both a correlation and a discrete Fourier transform (DFT) approaches, is presented here. In the correlation approach, the blind phase shift is calculated via the correlation coefficient between two similar speckle interferograms (SI) differing only by the reference wave phase shift. The DFT approach is based on the blind phase shift extraction from frequency components of SI Fourier spectra. Comparative analysis of these approaches has testified to their high performance. Moreover, it is shown that the correlation approach is more preferable for blind phase shift extraction from SIs with a rough surface than from interferograms with a smooth surface; hence, it is more convenient for ESPI than for phase-shifting interferometry. In addition, this approach provides a lesser level of systematic error of extracted phase shift in comparison with the DFT. The correlation approach was used for experimental definition of Poisson’s ratio for duralumin constructional material by the two-step ESPI method.
1 November 2012 in Optics and Lasers in Engineering
A method for evaluation of fatigue process zone (FPZ) dimensions near a notch root in metal and alloy specimens by using a two-step phase shifting interferometry (TS PSI) technique is proposed. In comparison with other destructive and nondestructive methods evaluating the FPZ dimensions, it possesses higher accuracy and performance. The method uses a criterion for the FPZ dimensions definition based on an assumption that the surface roughness of notched specimens after cyclic loading reaches its maximum values at the FPZ boundary. To realize this method, first, a phase map (PM) of a total surface relief near a notch root is retrieved; second, roughness and waviness PMs are extracted from the retrieved total surface relief PM by using the TS PSI; and finally, a surface roughness parameter spatial distribution is calculated according to the offered criterion and the FPZ size is defined. The FPZ size was measured for specimens made of low-carbon steel and aluminum alloys 2024-Т6 and 7075-T3. Obtained experimental results have shown that the proposed criterion allows defining the FPZ size for notched specimens made of metals and alloys possessing high, moderate, and low plasticity.