The compositional similarity of calcium phosphates such as β-TCP and HAp to the inorganic components of human bones makes them excellent candidates for bone substitutes. Regardless of presenting excellent biocompatibility, calcium phosphates present low mechanical strength, which is a major drawback for load-bearing applications. In this sense, achieving Hap or β-TCP with increased density is crucial to enhance their mechanical properties. In the present study, β-TCP and HAp were processed from commercially available powders in order to obtain highly dense specimens aiming to elevate these mechanical properties of calcium phosphates. For this purpose, two sintering strategies were used: in the first, using a single holding time, whereas in the second, two holding times. The obtained phases, their potential degradation, microstructure, porosity, and mechanical strength were investigated. Results revealed that the use of two holding times improved densification, leading to flexural strength improvement, on both materials, but especially on HAp, where a 122% increase was verified.
Magnesium (Mg) and its alloys are promising materials for a wide range of biomedical applications due to its biodegradability. Nevertheless, their rapid corrosion dictates the need to develop strategies to control these materials’ corrosion rate. In fact, several surface modification techniques have been used to retard the corrosion of Mg and its alloys. Laser technology can be used to tailor Mg surfaces aiming to modify exposed area/roughness and thus control the biocorrosion process. This work presents a detailed study on pure Mg surface texturing by an Nd:YAG laser and their morphological characterisation, aiming to create either localised texturing or remelted areas. The characterisation of the textured and remelted surfaces was carried out by scanning electron microscopy and analysed using image analysis software (Image J) for obtaining their depth and width. Results show that higher scan speed (400 mm/s) and lower laser power (1.5 W) were unsuitable for machining pure Mg. The parameters to perform texturing and remelting are discussed herein.
Tooth loss during the lifetime of an individual is common. A strategy to treat partial or complete edentulous patients is the placement of dental implants. However, dental implants are subject to bacterial colonization and biofilm formation, which cause an infection named peri-implantitis. The existing long-term treatments for peri-implantitis are generally inefficient. Thus, an electrical circuit was produced with zirconia (Zr) samples using a hot-pressing technique to impregnate silver (Ag) through channels and holes to create a path by LASER texturing. The obtained specimens were characterized according to vitro cytotoxicity, to ensure ZrAg non-toxicity. Furthermore, samples were inoculated with Staphylococcus aureus using 6.5 mA of alternating current (AC). The current was delivered using a potentiostat and the influence on the bacterial concentration was assessed. Using AC, the specimens displayed no bacterial adhesion (Log 7 reduction). The in vitro results presented in this study suggest that this kind of treatment can be an alternative and promising strategy to treat and overcome bacterial adhesion around dental implants that can evolve to biofilm.