The use of CH4 and CO2 as fuels in direct internal reforming solid oxide fuel cells (DIR-SOFCs) is a promising strategy for efficient power generation with reduced greenhouse gas emissions. In this study, Ni catalysts supported on Ce–Pr mixed oxides with varying Pr contents (0–80 mol%) were synthesized, calcined at 1200 °C, and tested for dry reforming of methane (DRM), aiming at their application as catalytic layers in SOFC anodes. Physicochemical characterization (XRD, TPR, TEM) showed that increasing Pr loading enhances catalyst reducibility and promotes the formation of the Pr2NiO4 phase, which contributes to the generation of smaller Ni0 particles after reduction. Catalytic tests revealed that all samples exhibited low-carbon deposition, attributed to the large Ni crystallites. The catalyst with 80 mol% Pr showed the best performance, achieving the highest CH4 conversion (72%), a H2/CO molar ratio of 0.89, and improved stability. These findings suggest that Ni/Ce0.2Pr0.8 could be a promising candidate for use as a catalyst layer of anodes in DIR-SOFC anodes. Although electrochemical data are not yet available, future work will evaluate the catalyst’s performance and durability under SOFC-relevant conditions.
RESUMO O hidrogênio é um produto de grande apelo industrial, ainda mais quando proveniente de uma cadeia renovável de baixo impacto ambiental. Visando a redução de custos relacionados ao preparo dos catalisadores utilizados para a obtenção de H2, o presente trabalho teve como objetivo avaliar a influência de dois diferentes suportes de Si-MCM-41, sintetizados a partir de duas diferentes fontes de sílica (uma comercial, ortossilicato de tetraetila – TEOS e outra residual, sílica de cinzas de casca de arroz – CCA), no desempenho de catalisadores de níquel quando aplicados na reação de reforma a seco do metano (RS). Os catalisadores foram sintetizados com 20% (m/m) de níquel por meio de impregnação úmida e foram caracterizados pelas técnicas de MEV/EDS, fisissorção de N2, DRX, FTIR, TPD–NH3 e TPR. Os ensaios reacionais foram conduzidos em reator de leito fixo, a 800 ºC por 24 h. Os resultados de caracterização do material evidenciaram que a síntese catalisadores foi eficiente. Os catalisadores apresentaram significativas diferenças estruturais se tratando das diferentes fontes de sílica utilizadas na síntese do suporte catalítico, diferenças essas que foram mais evidentes na área específica e no diâmetro de poros dos materiais. Essa diferença pode estar relacionada com a diferença morfológica do suporte catalítico que influencia diretamente na maneira com a qual a fase ativa ficará disposta na superfície do catalisador. A avaliação dos produtos gasosos, realizada por cromatografia gasosa, evidenciou resultados de conversão e seletividade muito semelhantes para os dois catalisadores, levando a conversões de 45% de H2. A formação de coque no catalisador no qual o suporte precursor foi sintetizado a partir de CCA foi significativamente menor. Nesse sentido, a CCA se destaca como um promissor substituinte para o TEOS na síntese de suportes catalíticos para catalisadores de níquel de alta performance quando aplicados na RS.
Mg(Al)O is a promising catalyst for the Guerbet synthesis, promoting high yields of 1-butanol at low temperature and short contact time. However, rapid catalyst deactivation is observed under reaction conditions. Combining in situ DRIFTS with XPS, XRD, and DTG analyses, two main deactivation pathways were identified. The first involves the interaction of acetaldehyde, a key reaction intermediate, with Mg(Al)O, leading to the formation of surface acetate species. The second is associated with hydrotalcite formation on the Mg(Al)O surface during the reaction. This process occurs through the reaction of water, a product of 1-butanol synthesis, with the mixed oxide due to the memory effect. Importantly, both deactivation modes are reversible, and an oxidation treatment restores the catalytic performance of Mg(Al)O for 1-butanol synthesis from ethanol.To the best of our knowledge, this is the first report associating Mg(Al)O deactivation with hydrotalcite formation employing ethanol as a reagent.