Subsurface physical barriers have been effectively used to mitigate seawater intrusion (SWI). Traditionally, the primary emphasis in both numerical studies and practical implementations has been on vertical barriers. The current research aims to explore the dynamics of SWI under various cutoff-wall inclination angles and depths, as well as aquifer heterogeneity using both experimental and numerical simulations. The impact of aquifer characteristics was assessed by utilizing a low hydraulic conductivity (K) aquifer (case L), a high hydraulic conductivity aquifer (case H), and two stratified aquifers. The stratified aquifers were created by grouping different hydraulic conductivity layers into two cases: high K above low K (case H/L) and low K above high K (case L/H). The model simulations covered seven different cutoff-wall inclination angles: 45.0°, 63.4°, 76.0°, 90.0°, 104.0°, 116.6°, and 135.0°. The maximum repulsion ratio of SWI wedge length was observed at an inclination angle of 76.0° for cutoff-wall depth ratios up to 0.623. However, as the depth ratio increased to 0.811, the maximum repulsion ratio shifted to an angle of 63.4° for all aquifers studied. At an inclined cutoff depth ratio of 0.811, the cutoff-wall inclination angle of 45.0° had the most significant impact on the saltwater wedge area. This results in SWI area reductions of 74.9%, 79.8%, 74.7%, and 62.6% for case L, case H, case H/L, and case L/H, respectively. This study provides practical insights into the prevention of SWI. Nevertheless, a thorough cost–benefit analysis is necessary to assess the feasibility of constructing inclined cutoff-walls.

Saltwater intrusion is a prevalent global environmental issue that detrimentally impacts coastal groundwater aquifers. This problem is exacerbated by climate change and increased groundwater abstraction. Employing physical barriers proves effective in mitigating saline water intrusion. In this study, a validated numerical simulation model is utilized to assess the impact of aquifer stratification on the effectiveness of mixed physical barriers (MPBs) and their response to structural variations. Additionally, the performance of MPBs was compared with that of single physical barriers in a laboratory-scale aquifer. Three different configurations were replicated, comprising two stratified aquifers (HLH and LHL) and a homogenous reference aquifer (H). The results demonstrate that MPBs are efficient in decreasing the saltwater penetration length in the investigated cases. The reductions in penetration length were up to 65% in all cases. The removal efficacy of residual saline water for MPBs exceeded that of the subsurface dam by 2.1–3.3 times for H, 2.1–3.6 times for HLH, and 8.3 times for LHL conditions, while outperforming the cutoff wall by 38–100% for H, 39–44% for HLH, and 2.7–75% for LHL. These findings are of importance for decision-makers in choosing the most appropriate technique for mitigating saline water intrusion in heterogeneous coastal aquifers.

Saltwater intrusion (SWI) is a widespread environmental problem that poses a threat to coastal aquifers. To address this issue, this research employs both numerical and experimental methods to study saltwater intrusion under the impact of sea level rise and varying freshwater boundary conditions in two homogeneous aquifers. The study compares transient numerical groundwater heads and salt concentrations to experimental results under receding-front and advancing front conditions. In the low permeability aquifer, the root mean square error is 0.33 cm and the R2 is greater than 0.9817. Similarly, in the high permeability aquifer, the root mean square error is 0.92 cm and the R2 is greater than 0.9335. The study also compares the results of ten experimental tests for steady-state saltwater intrusion wedge and toe length with seven different analytical solutions. The experimental results are then compared to these analytical solutions to find the most suitable equation. The Rumer and Harleman equation shows good agreement with experimental saltwater intrusion wedge, while the Anderson equation is a good fit for saltwater intrusion toe length. Overall, this research provides valuable insights into saltwater intrusion in coastal aquifers, and the findings can be used to inform policies and management strategies to mitigate the negative impacts of saltwater intrusion. The investigation shed light on how inland water head and Sea Level Rise (SLR) affect SWI behavior.