Lusheng Zhai

Dr. Lusheng Zhai

School of Electrical and Information Engineering, Tianjin University, Tianjin, China
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 November 2019 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
DWDayang Wang
Dayang Wang
NJNingde Jin
Ningde Jin
Lusheng ZhaiLusheng Zhai
Lusheng Zhai
YRYingyu Ren
Yingyu Ren
A novel coaxial three-electrode distributed conductance sensor (CTDCS) is proposed to achieve salinity and oil content independent measurement of liquid film thickness in multiphase slug flow. Conductance sensor obtains liquid film thickness by measuring the conductance between electrodes. However, the conductance depends on the liquid film thickness and the liquid conductivity. For gas-water and oil-gas-water flows in industrial process, the variations of salinity and oil content of liquid phase change the liquid conductivity. This will seriously affects the measurement of liquid film thickness using conventional two-electrode sensor. Owing to its novel three-electrode configuration, the proposed CTDCS can overcome the problem mentioned above. The optimal geometry of CTDCS are determined by exhaustive search using finite element method, and the electronic circuit suitable for the condition of conductivity variation is investigated. The ratio of two-channel outputs which is independent of conductivity is acquired and its relationship with the liquid film thickness is established. The advantages of the CTDCS are that it can on-line compensate conductivity variations, and acquire the circumferential distribution of liquid film thicknesses. Hence, salinity and oil content independent measurement of liquid film thickness is realized for the first time.

22 May 2018 in Measurement Science and Technology
Verified
Journal Article
Closed access
PDF file
DWDa-Yang Wang
Da-Yang Wang
NJNingde Jin
Ningde Jin
LZLian-Xin Zhuang
Lian-Xin Zhuang
Lusheng ZhaiLusheng Zhai
Lusheng Zhai
YRYing-Yu Ren
Ying-Yu Ren
Three types of rotating electric field conductance sensors (REFCSs) with four, six, and eight electrodes are designed and optimized in this paper to measure the water holdup of oil–gas–water three-phase flow in vertical upward 20 mm inner diameter pipe. The geometric parameters of the REFCSs are optimized using finite element method to access highly sensitive and homogeneous detection fields. The performance of the REFCSs in the water holdup measurement of three-phase flows is experimentally evaluated by generalizing the Maxwell equation. Based on the measured water holdup from the REFCSs, the slippage behaviors in oil–gas–water are uncovered and the superficial velocity of the water phase is determined. The results show that the REFCSs present a high resolution in the water holdup measurement. The REFCS with eight electrodes has better performance than those with four- and six-electrodes, which indicates that its configuration and geometric parameters are more suitable for vertical oil–gas–water three-phase flow measurement in 20 mm inner diameter pipe.

31 July 2020 in IEEE Sensors Journal
Verified
Journal Article
Closed access
NJNingde Jin
Ningde Jin
CYChuang Yu
Chuang Yu
YHYunfeng Han
Yunfeng Han
QYQiuyi Yang
Qiuyi Yang
YRYingyu Ren
Yingyu Ren
Lusheng ZhaiLusheng Zhai
Lusheng Zhai
Since the responses of the electromagnetic flowmeter (EMF) can be affected by the flow characteristics, the combination of the EMF and the void fraction meter is always necessary for the two-phase flow measurement. Combined with a plug-in conductance sensor array (PICSA), the measurement characteristics of the EMF in low-velocity oil-water two-phase flows are investigated in this study. In a low-velocity oil-water flow experiment, the water holdup of the oil-water flows at low velocity is measured by the PICSA. By introducing correction coefficients of the EMF under different flow patterns, the correlations between the EMF responses and the oil holdup are established to measure the water superficial velocity. Finally, the oil superficial velocity is accurately predicted by a drift flux model derived from the liquid holdup and mixture velocity. Satisfactory prediction accuracy for the oil superficial velocity can be achieved without the need to introduce oil velocity measurement as in previous studies.

31 May 2020 in Sensors
Verified
Journal Article
Open access
PDF file
QYQiu-Yi Yang
Qiu-Yi Yang
NJNingde Jin
Ningde Jin
Lusheng ZhaiLusheng Zhai
Lusheng Zhai
YRYing-Yu Ren
Ying-Yu Ren
CYChuang Yu
Chuang Yu
JWJidong Wei
Jidong Wei
A method to measure the superficial velocity of the water phase in gas–water flow using an electromagnetic flowmeter (EMF) and rotating electric field conductance sensors (REFCSs) is introduced in this paper. An electromagnetic flowmeter instrument factor model is built and the correlation between electromagnetic flowmeter output and gas holdup in different flow patterns are explored through vertical upward gas–water flow dynamic experiments in a pipe with an inner diameter (ID) of 20 mm. Water superficial velocity is predicted based on pattern identification among bubble, churn, and slug flows. The experimental results show that water superficial velocity can be predicted fairly accurately for bubble, churn, and slug flows with a water cut higher than 60% (absolute average percentage deviation and absolute average deviation are 4.1057% and 0.0281 m/s, respectively). The output of the electromagnetic flowmeter is unstable and invalid in slug flows with a water cut below 60% due to the non-conducting gas slug is almost filling the pipe. Therefore, the electromagnetic flowmeter is not preferred to be used in such conditions.

10 September 2018 in Measurement Science and Technology
Verified
Journal Article
Closed access
PDF file
DWDa-Yang Wang
Da-Yang Wang
NJNingde Jin
Ningde Jin
Lusheng ZhaiLusheng Zhai
Lusheng Zhai
YRYing-Yu Ren
Ying-Yu Ren
To be able to deduce water holdup from the mixture conductivity measured by conductance sensors in water continuous oil–gas–water three-phase flow, the water conductivity must be known in advance. As water conductivity depends on water salinity and temperature, variation in water salinity or temperature changes the water conductivity, which seriously affects water holdup measurement. In this study, we propose a novel online technique to detect the conductivity of water in vertical upward oil–gas–water flows in 20 mm inner diameter pipe via the conductance method. A water conductivity sensor (WCS) is designed and the geometry of the electrodes in its water trapping cavity is optimized using finite element methodology. After this, the relationship between sensor response and water conductivity is investigated. WCS performance is experimentally evaluated and the results show that the WCS can effectively detect the water conductivity in a three-phase mixture online. By correcting the water conductivity in the expression for the normalized conductivity of a rotating electric field conductance sensor, water salinity and temperature independent water holdup measurement can be realized. Based on the relationship between the calculated water holdup and water cut, the superficial velocity of water is accurately predicted despite differences in water conductivity.

26 July 2019 in IEEE Sensors Journal
Verified
Journal Article
Closed access
WRWeikai Ren
Weikai Ren
NJNingde Jin
Ningde Jin
Lusheng ZhaiLusheng Zhai
Lusheng Zhai
YRYingyu Ren
Yingyu Ren
A distributed ultrasonic method for measuring the liquid film thickness of vertical multiphase slug flow and churn flow widely existed in industrial production is proposed in this paper. First, according to the proportional relationship between transit time of ultrasonic echo and liquid film thickness, we use the twin-crystal ultrasonic probe to measure the local thickness of liquid film. In view of the non-uniform circumferential distribution of the liquid film, three ultrasonic probes are installed on the same pipe section to measure the circumferential distribution of liquid film thickness. Then, a high-speed data acquisition system suitable for multi-channel and a data transmission system based on gigabit network are designed. The experiments of gas-liquid two-phase flow and oil-gas-water three-phase are carried out in a vertical pipe with a diameter of 20 mm. The fluctuation of local liquid film thickness has been measured by the distributed ultrasonic sensor, and the average thickness of liquid film of slug flow and churn flow under different flow conditions is obtained. The result indicates that the average liquid film thickness of slug flow and churn flow gradually thickens with the increase of liquid superficial velocity, and the distributed ultrasonic sensor can accurately measure the change of film thickness.