Progressive research on reducing engine emissions is highly valued due to the emissions’ significant environmental and health impacts. This comprehensive comparative study examines the catalytic efficiency of manganese (Mn) and cerium silica (Ce-Si) synthesis catalyst-based molds in a diesel engine using a selective catalytic reduction (SCR) technique with diesel and diesel–plastic oil blend (DPB) (B50). In addition to Fourier transform infrared spectroscopy (FTIR) studies, X-ray diffraction (XRD), scanning electron microscopy (SEM), and the Brunauer–Emmett–Teller (BET) method are utilized to characterize the produced molds before and after exhaust gas passes. The Ce-Si-based mold demonstrates superior redox capacity, better adsorption capacity, and better thermal stability, attributed to enhanced oxygen storage and structural integrity compared to the Mn-based mold. Under minimum load conditions, nitrogen oxide (NO) reduction efficiency peaks at 80.70% for the Ce-Si-based mold in the SCR treatment with DPB fuel. Additionally, significant reductions of 86.84%, 65.75%, and 88.88% in hydrocarbon (HC), carbon monoxide (CO), and smoke emissions, respectively, are achieved in the SCR treatment under optimized conditions. Despite a wide temperature range, Ce-Si-based mold promotes high surface area and superior gas diffusion properties. Overall, the Ce-Si-based mold provides efficient emission control in diesel engines, which paves a path for developing better environmental sustainability. The outcomes contribute to advancing environmental sustainability by supporting the achievement of SDGs 7, 11, and 13.
Selective Catalytic Reduction (SCR) helps to reduce Nitrogen Oxide (NO) emissions from diesel engines using catalytic materials made of thermally stable non-precious metals. A dual support SCR catalyst using iron oxide (Fe 2 O 3 ) and silica/alumina (SiO 2 /Al 2 O 3 ) has developed from low-cost materials. This catalyst has a monolith design for application to engines at full scale. The dual support provides a high level of interface between the iron oxide and silica/alumina that allows higher iron loadings, better iron distribution, and greater thermal stability of the Fe 3+ /Fe 2+ redox couples across a wide temperature range (150–600 °C). Analytical techniques like (X-ray Diffraction (XRD), Scanning Electron Microscopy (SEM), Brunauer–Emmett–Teller Surface Area (BET) and Fourier Transform Infrared (FTIR) Spectroscopy confirmed the presence of a thermally stable and mesoporous catalyst with an even distribution of Lewis and Bronsted acid sites. Industrial applications of this catalyst have been performed on a diesel engine fuel as a diesel and diesel plastic oil blend (DPB) (B50) with a power output of 5.2 kW and significant conversion rates of 85% of NO at maximum load, and Hydrocarbons (HC), Carbon Monoxide (CO) and smoke opacity have been reduced by 65%, 55%, and 60%, respectively. Statistical analysis of results across all experimental conditions, including ANOVA, was conducted to establish the reproducibility of the findings. This catalyst exhibited consistent activity when tested with conventional diesel fuel as well as blended fuels composed of diesel and post-industrial waste. No precious metals or polymers have been used in the synthesis of the dual support SCR catalyst or subsequent formulations for commercial application. Overall, the results demonstrated that low-cost precursors could serve as effective catalysts for reducing NO emissions from diesel engines.