Over-the-horizon radars (OTHRs) have recently been making a comeback in Canada. As the need for accurate long-range tracking becomes more important, less-expensive ground-based radars are once again being considered for more effective long-range surveillance of Canadian airspace. Ray tracing is a powerful tool and is, especially, useful in applications requiring a detailed knowledge of radio wave propagation through the ionosphere. In this letter, new methods are developed to determine the feasible radar parameters such as operating frequencies, elevation angles, and absorption for OTHR operation using a 3-D ray tracing technique and up-to-date ionospheric, magnetic, and absorption models. The results of these simulations can be used for frequency monitoring systems and other OTHR applications in Canada.
26 July 2019 in IEEE Geoscience and Remote Sensing Letters
Sky-wave over-the-horizon radar (OTHR) systems are of particular interest to the Canadian Department of National Defence (DND) since they provide the potential for surveillance of Canada. Because of dynamic ionospheric conditions in polar regions, any OTHR would necessitate a system where the operating frequencies and elevation angles change periodically to maintain constant detection of targets downrange. In this regard, an accurate electron density model is necessary for the purpose of improving operational OTHR and OTHR planning/design. Recently, the first phase of the Empirical Canadian High Arctic Ionospheric Model (E-CHAIM) was released, which was funded under the Defence Research and Development Canada's (DRDC) All Domain Situational Awareness (ADSA) program. In this letter, the E-CHAIM is used to determine the feasible radar parameters such as operating frequencies and elevation angles by a 3-D ray-tracing technique. The results will help to form the basis of the frequency monitoring systems (FMS) that will control these polar OTHR systems.
In many applications, it may be desired to decompose a non‐stationary signal into its individual components. If spectral components of the non‐stationary signal do not overlap in the frequency domain then Fourier transform can be used to decompose the non‐stationary signal. Fourier transform fails to decompose the non‐stationary signal if its spectral components overlap in the frequency domain. In this study, the authors propose Fourier‐Bessel transform and the time–frequency analysis in conjunction with the fractional Fourier transform (FB‐TF) method for the separation of multi‐component non‐stationary signal whose components overlap in both time and/or frequency domains. The efficiency of the proposed method is compared with one of the traditional decomposition methods like EMD. The proposed approach is applied to both simulated and experimental radar data. Results demonstrate the effectiveness of the proposed method for non‐stationary signal separation and for detecting manoeuvring target in heavy sea‐clutter environments. The improvement factor and clutter attenuation are calculated and used to compare the performance of the EMD and the FB‐TF methods in suppressing the sea‐clutter and enhancing target detection. The proposed method can be used as a potential tool for detecting and enhancing the low observable manoeuvring air targets in the sea‐clutter environment.
21 July 2022 in IEEE Transactions on Geoscience and Remote Sensing
Sky-wave over-the-horizon radar (OTHR) propagates radio waves off the ionosphere to provide long-range surveillance around the Earth’s curvature. Frequency selection for high-latitude and polar OTHRs is challenging unless there is an environmental monitor that addresses the significant ionospheric variability in high-latitude regions, a spectrum monitor that finds unoccupied frequencies in the high-frequency (HF) radio waveband, and a frequency management system (FMS) that selects an optimal frequency from the merged results of the environmental monitor and spectrum monitor. This article describes the first FMS for high-latitude OTHR that merges results from the environmental monitor and spectrum monitor in real-time. The environmental monitor uses the assimilative Canadian high-arctic ionospheric model (A-CHAIM), which assimilates near-real-time data and is, to date, the most advanced ionospheric model for high-latitude regions. Despite remaining limitations, demonstrations of this real-time FMS between a transmitter and four targets during the day and night and during fall and summer show that it could be one of the tools for selecting frequencies for operational scenarios.
14 January 2021 in IEEE Geoscience and Remote Sensing Letters
High-frequency over-the-horizon radars (OTHR) provide an economical means to detect and track noncooperative air targets over large expanses of land and sea. Due to the dynamic nature of the ionosphere, an OTHR requires a frequency management system where the operating frequencies and launch angles (azimuth and elevation) change periodically to maintain constant target detection. Accurate electron density models are required for the purpose of improving OTHR performance and for system planning and design. This is particularly true in the polar regions where large-scale electron density structures taking the form of patches and arcs of enhanced electron density are the common features of the F-region ionosphere. These structures form tilted reflection surfaces for HF radiowaves and result in propagation well displaced from the great circle direction. The effects of patches on the ray paths have been simulated, and their impact on OTHR frequency management is illustrated.
1 August 2021 in Journal of Atmospheric and Solar-Terrestrial Physics